Investigation of the Effect of Milling Time on Elemental Powders of Oxi‐Reduction Nickel and Hydrogenation–Dehydrogenation Titanium

Rodolfo da Silva Teixeira,Mônica Aline Magalhães Gurgel,Patrícia Freitas Rodrigues,Bruno Xavier de Freitas,Naiara Vieira Le Sénéchal,Rebeca Vieira de Oliveira,Filipe Carlos Figueiredo Pereira Neves,Andersan dos Santos Paula

DOI: https://doi.org/10.1002/adem.202401031

IF: 3.6

2024-10-27

Advanced Engineering Materials

Abstract:This study examines the effect of milling time on the recycling of Ni and Ti elemental powder using mechanical alloying. A 25 min milling time produces a homogeneous lamellar microstructure of nickel and titanium, with lower intermetallic formation temperatures and improved powder yield. This reduced milling time enhances technological efficiency, surpassing previous results by decreasing processing time and increasing yield. Mechanical alloying (MA) is widely applied in the synthesis of blended elemental or prealloyed powders. This work evaluates the effect of milling time on elemental nickel and titanium powders produced by oxi‐reduction and the hydrogenation–dehydrogenation process, respectively. The powders are characterized by scanning electron microscopy, X‐ray diffraction, particle size, powder yield, and differential scanning calorimetry. It is observed that increasing the milling time promotes the formation of a structure composed of thin lamellae of nickel and titanium, which results in the beneficial effect of lowering the temperature for the formation of the intermetallic of the Ni–Ti system and in the powder yield achieved. The reduction of milling time in the MA process of NiTi alloys enhances technological efficiency by decreasing their overall processing time.

materials science, multidisciplinary