Abstract:Determination of total antioxidant capacity (TAC) in foods is very important for combating oxidative stress-induced diseases. For this purpose, an amperometric sensor was developed for TAC determination by manufacturing a new electrode consisting of a copper(II)-neocuproine (Cu(II)–Nc) and carrageenan-multi-walled nanotube suspension functionalized on a glassy carbon electrode, named as Cu(II)–Nc/Car-MWCNT/GCE. Cyclic voltammetric studies showed that the modified electrode exhibits a very well-formed reversible redox couple for the Cu(II)–Nc/Cu(I)–Nc complex. For amperometric sensor preparation, the Cu(II)–Nc cationic chelate was electrostatically retained on the electrode with the anionic groups of Car (a sulfated biopolymer of low cost) and immobilized on the surface. Cu(II)–Nc was reduced to Cu(I)–Nc on the electrode with the addition of antioxidants under constant potential, thereby functioning as an electron-transfer mediator. Thus, the individual antioxidant compounds were not measured at their own peak potentials but were indirectly measured at a common potential through their ability to reduce cupric-to-cuprous neocuproine. The reoxidation current of Cu(I)–Nc showing a proportional increase with antioxidant concentration was recorded, resulting in increased sensitivity and selectivity. This anodic current intensity of Cu(I)–Nc correlated with the total antioxidant capacity (TAC) of real samples such as plant extracts, reflecting the combined reducing ability of all antioxidants in the sample. Calibration graphs of antioxidants were obtained by optimizing the working conditions. The current intensity of Cu(I)–Nc arising from trolox varied linearly with concentration in the range of 4.98–84.39 μM. The limit of detection and limit of quantification values for trolox were found to be 0.59 and 1.99 μM, respectively. The developed method selectively responded to food antioxidants, and was not affected by potential interferent ions and molecules commonly found in foods. The TAC values of real samples such as herbal teas, plant extracts, and fruit juices were calculated and compared with those found by the conventional spectrophotometric CUPRAC method.

Chronoamperometric Determination of Antioxidant Capacity Using an Iron Complex with 2,2'-Bipyridine

Evaluation of antioxidants using oxidation reaction rate constants

Potentiometry in determining the antioxidant capacity of compounds of different hydrophilicity in the joint presence using mixed solvents and surfactants

Rapid Determination of Lipid Peroxidation Using a Novel Pyridoxamine-Participating Ferrous Oxidation-Sulfosalicylic Acid Spectrophotometric Method.

An Electrochemical Method for Sensitive Determination of Antioxidant Capacity

[Method of colored model radicals for assessment of oxidative equilibrium in biologic samples]

A novel flow injection amperometric method for sensitive determination of total antioxidant capacity at cupric-neocuproine complex modified MWCNT glassy carbon electrode

Determination of the Antioxidant Activity of Samples of Tea and Commercial Sources of Vitamin C, Using an Enzymatic Biosensor

Analytical Methods Used in Determining Antioxidant Activity: A Review

Influence of pH, buffers and role of quinolinic acid, a novel iron chelating agent, in the determination of hydroxyl radical scavenging activity of plant extracts by Electron Paramagnetic Resonance (EPR)

Assessment of Matrix Effect on the Results of the Potentiometric Determination of Antioxidant Capacity

Spectrophotometric Determination of Hydrogen Peroxide, Glucose, Uric Acid, and Cholesterol Using Peroxidase-like Activity of an Fe(III) Complex of Thiacalix[4]arenetetrasulfonate Attached to an Anion-exchanger

Microwave-assisted Extraction Followed by Capillary Electrophoresis-Amperometric Detection for the Determination of Antioxidant Constituents in Folium Eriobotryae

Portable Device for Potentiometric Determination of Antioxidant Capacity

On-line HPLC Method for Screening of Antioxidants Against Superoxide Anion Radical from Complex Mixtures.

Folin–Ciocalteu Reagent-Loaded Acrylamide-Based Hydrogel Sensor for Antioxidant Capacity Measurement with the Molybdenum Green Method

A preliminary study on a new approach for measurement of the antioxidant capacity of single molecules in food

A new method of measuring the antioxidant activity of polyphenols using cumene hydroperoxide

Three ABTS•+ radical cation-based approaches for the evaluation of antioxidant activity: fast- and slow-reacting antioxidant behavior

Amperometric sensor for total antioxidant capacity measurement using Cu(II)-neocuproine/carrageenan-MWCNT/GCE