Abstract:Abstract The high-speed on/off valve (HSV) is the core component of a digital hydraulic system. Current research mainly focuses on single coil spool-type HSVs, with limited investigation into coil optimization for multi-coil integrated HSVs. Developing high-performance HSVs with integrated multi-coils presents ongoing challenges, particularly in achieving low temperature rise, rapid response, and controllability. To address these challenges, this study proposes an optimization method for the integrated HSVs, harmonized with voltage control strategies to augment dynamic performance within digital valve systems. The investigation introduces a multi-coil integrated digital hydraulic valve and delves into the functional correlations among coil volume, temperature rise, and input power through both simulation and experimental methods. Leveraging multi-objective optimization techniques rooted in meta model of optimal prognosis (MOP) and evolutionary algorithm (EA), the design methodology refines the valve winding. The simulation results demonstrate that, firstly, under temperature rise constraints, coils designed with a four-voltage control strategy, compared to those developed based on single and three-voltage control strategies, will experience a reduction in opening time by 50% (from 2.0ms to 1.0ms) and 71.4% (from 3.5ms to 1.0ms), respectively, even if a four-voltage control strategy is applied subsequently. Secondly, if a single voltage control strategy is adopted for coils optimally designed based on three or four-voltage control strategies, the coil temperature may exceed the allowable limit, leading to coil burnout. Finally, regardless of the voltage control strategy used to obtain the coils, subsequent adoption of the three voltage control strategy results in the lowest coil temperature rise.

The modeling and analysis of operating characteristics and temperature drift of deflector jet servo valve under the wide temperature range

Mechanism of temperature-induced zero drift on electro-hydraulic servo valve

Mathematical model and experimental verification of high flow cartridge servo valve

Model Construction and Performance Degradation Characteristics of a Deflector Jet Pressure Servo Valve under the Condition of Oil Contamination

Steady Flow Torques in a Servo Motor Operated Rotary Directional Control Valve

Optimization of Integrated High-Speed On/Off Valve Aligned with Voltage Control Strategies for Enhanced Dynamic Performance in Digital Hydraulic Systems

The Design of Temperature Control System in Giant Magnetostrictive Actuator

Numerical Investigation of Flow Force and Cavitation Phenomenon in the Pilot Stage of Electrical-Hydraulic Servo Valve under Temperature Shock

Analysis of Performance Effect Factors of Three-Stage Electro-Hydraulic Servo Valve.

Heat Characteristics Analysis of Electro-Hydraulic Servo Valve

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

Nonlinear modeling and parameter optimization of the pilot stage applied to the deflector-jet servovalve

Fluid Dynamics Investigation on the Body Structure Inside a Sleeve Regulating Valve

Evaluation of the Viscous Heating Induced Jam Fault of Valve Spool by Fluid–structure Coupled Simulations

Modeling and Experimental Validation of the Time Delay in a Pilot Operated Proportional Directional Valve

Numerical Study On Temperature Field And Spool Deformation Of Throttle Slide Valve With V-Notches

Electromagnetic‐Thermal Analysis of High‐Temperature Direct Drive Electric‐Actuated Valve Canned Permanent Magnet Synchronous Motor

CFD-Based Physical Failure Modeling of Direct-Drive Electro-Hydraulic Servo Valve Spool and Sleeve

Modeling and Simulation Analysis of Speed-Regulating Valve Flow Fluctuations under Differential Pressure Steps

New modeling and analysis of three-stage electro-hydraulic servo valve

Analysis of the static and dynamic characteristics of the electro-hydraulic pressure servo valve of robot