Abstract:The reservoir type of the MH oil field in the Junggar Basin is a typical low-permeability conglomerate reservoir. The MH oilfield was developed by water injection in the early stage. Nowadays, the reservoir damage is serious, and water injection is difficult. There is an urgent need to carry out conversion injection flooding research to improve oil recovery. The use of CO2 oil-flooding technology can effectively supplement formation energy, reduce greenhouse gas emissions, and improve economic benefits. In order to clarify the feasibility of CO2 flooding to improve oil recovery in conglomerate reservoirs with low permeability, strong water sensitivity, and severe heterogeneity, this paper researched the impact of CO2 miscibility on production characteristics and mechanisms through multi-scale experiments. The aim was to determine the feasibility of using CO2 flooding to enhance oil recovery. This study initially elucidated the oil displacement characteristics of varying degrees of miscibility in different dimensions using slim tube experiments and long core experiments. Subsequently, mechanistic research was conducted, focusing on the produced oil components, changes in interfacial tension, and conditions for pore mobilization. The results indicate that the minimum miscibility pressure (MMP) of the block is 24 MPa. Under the slim tube scale, the increase in the degree of miscibility can effectively delay the gas breakthrough time; under the core scale, once the pressure reaches the near mixing phase, the drive state can transition from a non-mixed "closed-seal" to a "mixed-phase" state. Compared to the immiscible phase, the near-miscible and completely miscible phase can improve the final recovery efficiency by 9.27% and 18.72%. The component differences in the displacement products are mainly concentrated in the high-yield stage and gas breakthrough stage. During the high-yield stage, an increase in miscibility leads to a higher proportion of heavy components in the produced material. Conversely, in the gas breakthrough stage, extraction increases as the level of mixing increases, demonstrating the distinct extracting characteristics of different degrees of mixed phases. The core experiences significant variations in oil saturation mostly during the pre-gas stage. CO2 miscible flooding can effectively utilize crude oil in tiny and medium-sized pores during the middle stage of flooding, hence reducing the minimum threshold for pore utilization to 0.3 μm.

Monitoring of Flooding Characteristics with Different Methane Gas Injection Methods in Low-Permeability Heterogeneous Cores

Quantitative evaluation of water-alternative-natural gas flooding in enhancing oil recovery of fractured tight cores by NMR

Oil production performance and reservoir damage distribution of miscible CO2 soaking-alternating-gas (CO2-SAG) flooding in low permeability heterogeneous sandstone reservoirs

The Three-Dimensional Heterogeneous Simulation Study of CO2 Flooding in Low-Permeability Reservoirs

Characteristics and mechanisms of supercritical CO2 flooding under different factors in low-permeability reservoirs

Experimental investigation of CO 2 foam flooding-enhanced oil recovery in fractured low-permeability reservoirs: Core-scale to pore-scale

Laboratory Study on the Oil Displacement Process in Low-Permeability Cores with Different Injection Fluids

Characterization of Stages of CO2-Enhanced Oil Recovery Process in Low-Permeability Oil Reservoirs Based on Core Flooding Experiments

Characteristics and Mechanisms of CO2 Flooding with Varying Degrees of Miscibility in Reservoirs Composed of Low-Permeability Conglomerate Formations

Experimental investigation of CO2 foam flooding-enhanced oil recovery in fractured low-permeability reservoirs: Core-scale to pore-scale

Experimental Study on the Alternate Oil Displacement Mechanism of CO2 and Modified Water in Low-Permeability Oil Layers

Investigation on the flow behavior and mechanisms of water flooding and CO2 immiscible / miscible flooding in shale oil reservoirs

Experimental Study of the Dynamic Water–Gas Ratio of Water and Gas Flooding in Low-Permeability Reservoirs

Study on Enhanced Oil Recovery Mechanism of CO 2 Miscible Flooding in Heterogeneous Reservoirs under Different Injection Methods

Monitoring oil displacement and CO2 trapping in low-permeability media using NMR: A comparison of miscible and immiscible flooding

The Difference in Damage to Low-Permeability Reservoirs by Different Injection Methods of CO2 Flooding

Identification of Seepage Mechanisms for Natural Gas Huff-n-Puff and Flooding Processes in Hydrophilic Reservoirs With Low and Ultra-Low Permeabilities

Tailoring Water-Gas Ratios to Saturation Distribution for Improved Oil Recovery in Low-Permeability Reservoirs

Experimental study on CO2/Water flooding mechanism and oil recovery in ultralow - Permeability sandstone with online LF-NMR

Investigation of flue gas water-alternating gas (flue gas–WAG) injection for enhanced oil recovery and multicomponent flue gas storage in the post-waterflooding reservoir

Gas channeling control with CO 2 -responsive gel system in fractured low-permeability reservoirs: Enhancing oil recovery during CO 2 flooding