Abstract:For compartment fires with an opening, two distinct states are widely recognized: well-ventilated (oxygen is sufficient for combustion inside the compartment) and under-ventilated (oxygen is completely used inside the compartment). And as a consequence, the flame ejects out through the opening with excess fuel burning outside when reaching under-ventilated condition. However, in this work, a further transitional behavior of under-ventilated compartment fires with increasing fuel supply is revealed and quantified. Experiments were carried out using an under-ventilated fire compartment (0.4m cubic) with a fixed opening width (0.25 m) and various opening heights (0.0125 m to 0.15 m) (corresponding ventilation factors, A root H, 3.49 x 10(-4) to 1.45 x 10(-2) m(2.5)). The temperature inside the compartment and the facade flame ejected through the opening were recorded with increasing fuel supply (or namely total heat release rate) for under-ventilated conditions. The results showed that when the under-ventilated compartment fire reached a transitional state, the temperature inside the compartment experienced a sudden drop associated with a sudden increase of facade flame height outside the opening, posing a more severe impact on the building facade. The critical fuel supply rate for reaching the transitional state could be divided into two different mechanisms by a critical value of the opening ventilation factor ([0.5A root H]=0.0033 kg/s), based on the mass balance and flame stoichiometric extinction analysis inside the compartment. The formula for describing the critical fuel supply rate by considering the evolution of the critical air-fuel equivalence ratio (chi) for both mechanisms was proposed. The classic model on the facade flame height for common under-ventilated compartment fires was found to be not applicable when the transitional state of under-ventilated condition had been reached. A new model was proposed to correlate the facade flame height for the transitional state of under-ventilated condition, which was shown to have a 2/3 power dependence on the total heat release rate taking the opening width as the characteristic length. (C) 2019 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Reduced scale test bench for investigating the upward flame heat impact on external thermal insulation composite system facades

A New Hybrid Heating Method Used in Fire Test

Temperature Evolution Within Fire Compartment, External Flame Structure Characteristic and Merging Behavior with Multiple-Openings

Small-scale experimental study on EPS ETICS and flame-retardant coating reaction-to-fire performance

Effect of External Radiant Heat Flux on Upward Fire Spread: Measurements on Plywood and Numerical Predictions

Experimental study of compartment fire development and ejected flame thermal behavior for a large-scale light timber frame construction

Experimental Study on Flame Radiation Fraction of Facade Fire Ejected from Opening of a Compartment

Experimental Study on Upward Flame Spread of Exterior Wall Thermal Insulation Materials

Experimental study on fire behaviors of external thermal insulation composite system under vertical radiation

Evaluation of exterior wall cavity fires using an intermediate scale test method

Experimental Study on Evolution of Compartment Fire and Facade Flame Through an Opening with the Fire Source Attached to a Backwall at Different Elevations

Experimental Investigation of Externally Venting Flames Geometric Characteristics and Impact on the Façade of Corridor-Like Enclosures

Experimental Study of Transitional Behavior of Fully Developed Under-Ventilated Compartment Fire and Associated Facade Flame Height Evolution

Facade Flame Height Ejected from Opening of a Compartment under the Coupling Effect of Side Walls and Ambient Wind

Numerical investigation of externally venting flame characteristics in a corridor-façade configuration

Experimental and Numerical Investigations of Heat Impact and Flame Heights from Fires in SBI Tests

Heat Flux Distribution and Flame Shapes on the Inert Facade

Facade Flame Height Ejected from an Opening of Fire Compartment under External Wind

Application of Upward Flame Spread for the Prediction of SBI and ISO Room Corner (and Parallel Wall) Experiments and Classification

Experimental study on combustion phenomena of external wall thermal insulation material in the fire

Upward Fire Spread Rate Over Real-Scale EPS ETICS Façades