Flexural strength of 3D‐printed nanocomposite provisional resins: Impact of SiO2 and ZrO2 nanoparticles and printing orientations in vitro
Maram A. AlGhamdi,Fatimah M. Alatiyyah,Zainab H. Al Dawood,Farah Y. Alshaikhnasser,Rawan F. Almedarham,Shaymaa Y. Alboryh,Ahmed Elakel,Sultan Akhtar,Soban Q. Khan,Mohammed M. Gad
DOI: https://doi.org/10.1111/jopr.13829
2024-02-17
Journal of Prosthodontics
Abstract:Purpose The aim of this study was to investigate and compare the influence of zirconium dioxide nanoparticles (ZrO2NPs) and silicon dioxide nanoparticles (SiO2NPs) addition and printing orientation on the flexural strength (FS) of provisional three‐dimensional (3D) printing resins undergoing thermal cycling (TC). Methods Three dimensional‐printed resin (NextDent C&B MFH) was used to fabricate 300 bar‐shaped specimens (25 × 2 × 2 mm3). The ZrO2NPs and SiO2NPs specimens were divided into two groups, then subdivided into three groups, based on the nanoparticle concentration (i.e., 0 wt% (original group), 0.5 wt%, and 1 wt%). Each concentration was printed in three printing orientations (0°, 45°, and 90°). The printed specimens were exposed to 5000 cycles of TC, followed by a three‐point bending test to assess the FS. Fracture surface analysis was conducted by using a scanning electron microscope (SEM). For data analysis, ANOVA and Tukey's post hoc were utilized (α = 0.05). Results Compared to the original material, the addition of ZrO2NPs and SiO2NPs had a significantly positive impact on the FS, (P > 0.001). After TC, the FS of the original group decreased significantly and had the lowest value. The highest FS value was observed in 1% ZrO2NPs at 0°. Regardless of the nanoparticle concentration, the 0° orientation consistently showed a higher FS, compared to the 45° and 90° orientations. At all orientations (i.e., 0°, 45°, and 90°), the FS significantly increased with the addition of NPs, compared with that of the original material (P > 0.001). TC had a significantly negative effect on the FS of the unmodified groups. However, no significant differences existed in FS among the modified groups after TC. Conclusion The addition of SiO2NPs and ZrO2NPs increased the FS of the 3D‐printed provisional resin. Regardless of the nanoparticle concentration, the 0° orientation had the higher FS. TC had an effect on the original resin, whereas it had no significant effect on the nanoparticle‐modified resins. In clinical practice, 3D‐printed provisional nanocomposite resins printed at the 0° orientation could be recommended for long‐term dental provisional restorations.
dentistry, oral surgery & medicine