Abstract:Linear Fresnel collector system is a type of solar thermal utilization installation. It is mainly used to focus solar radiation on the receiver tube to generate high temperature thermal energy which can be applied in many aspects. This study investigates five different types of receiver tube models using water as the flowing medium, which leads to improving heat transfer performance by means of being equipped with enhancers. The optical results and thermohydraulic performance of the Linear Fresnel collector system are evaluated through Monte Carlo Ray Tracing and Computational Fluid Dynamics (CFD) simulation methods. The obtained optical results reveal that the distribution of energy flux density concentrating on the receiver tube surpasses that of the parabolic trough collector system. In order to maintain an energy reception rate of 90.0% or higher, the installation height range of the receiver tube should be between 1468–1532 mm. When the sun-tracking error increases from 0.0° to 1.0°, the overall optical efficiency of the Linear Fresnel collector system decreases from 98.9% to 79.7%. The thermohydraulic performance shows that the enhancers can generate a swirling flow as its main feature, which effectively promotes the homogenization of the temperature field and destroys the boundary layer near the receiver tube wall, thus greatly improving the convective heat transfer in the receiver tube. However, the introduction of the enhancers also means that the pressure drop loss of the receiver tube increases. Furthermore, the impact of the Kenics mixer's enhancer on heat transfer and flow characteristics is further amplified as the rotation rate decreases, owing to its alternating and complex structure. Through a comparative analysis of the influence of different receiver tube models on Nusselt number (Nu), Frictional resistance coefficient ( f ) and comprehensive evaluation criterion (PEC) under four rotation rate conditions (y = 6.3, 8.1, 11.34, 18.9), the conclusions present that the receiver tube with an enhancer at a low rotation rate has a larger Nu than that at a high rotation rate, while the Frictional resistance coefficient changes little at different rotation rates. Therefore, the PEC is higher when the receiver tube is equipped with a low-rotation-rate enhancer. Moreover, the receiver tube equipped with a Kenics mixer at a rotation rate of 6.3 was found to be the overall optimum case, with the PEC value varying from 1.47 to 1.73.

Comparative study of parabolic trough and linear Fresnel collectors from advanced exergy point of view

Experimental Investigation of a Small-Scale Parabolic Trough Concentrated Solar Power ‎Systems

Heat loss analysis review: Parabolic trough and linear Fresnel collectors

Comparative performance assessment of different absorber tube geometries for parabolic trough solar collector using nanofluid

Flat-Plate Solar Collector Thermal Performance and Optimal Operation Mode by Exergy Analysis and Numerical Simulation

Parabolic Trough Collector with Internal Fractal Fins in Receiver to Increase Thermal Performance in Working Fluid

Comparative Techno-Economic Analysis of Parabolic Trough and Linear Fresnel Collectors with Evacuated and Non-Evacuated Receiver Tubes in Different Geographical Regions

Analysis of the exergy performances of a glazed and unglazed PV/T collector under different conditions

Comparative Study on Two Photovoltaic and Thermal Solar Moduleds with Point-Focus Fresnel Concentrator

Impact of double-axis tracking on thermal performance of the linear Fresnel Collector: An experimental study

Heat transfer and exergy destruction analyses with ferrofluid in LS-3 solar collector under dipole magnetic field

Exergy and energy investigations of ET-150 PTSC with non-Newtonian nanofluid

A Hybrid Parabolic Trough Solar Collector System Integrated with Photovoltaics

Enhancing optical and thermohydraulic performance of linear Fresnel collectors with receiver tube enhancers: A numerical study

Techno-economic and environmental investigation between a low-concentrating photovoltaic thermal collector and a regular photovoltaic flat plate thermal collector

Hydrothermal performance assessment of a parabolic trough with proposed conical solar receiver

Thermodynamic assessment of a solar water heater and treatment: an energy–exergy and sustainability analysis

Experimental Study and Exergy Analysis About the Flat Plate Solar Collector

Thermal performance analysis of eccentric double-selective-coated parabolic trough receivers with flat upper surface

Energy and exergy analysis of conventional and modified flat-plate solar collector with dual spiral flow tubes: A comparative study

Performance Enhancement of Parabolic Trough Collector by Using Homogenizer and Spiral