Effect of silicon addition on the microstructures, mechanical properties and helium irradiation resistance of NiCoCr-based medium-entropy alloys

Shaofei Liu,Weitong Lin,Yilu Zhao,Da Chen,Guma Yeli,Feng He,Shijun Zhao,Ji-jung Kai

DOI: https://doi.org/10.1016/j.jallcom.2020.156162

IF: 6.2

2020-12-01

Journal of Alloys and Compounds

Abstract:<p>A series of NiCoCrSi_x (x = 0, 0.1, 0.2, 0.3) medium-entropy alloys were synthesized to investigate the effect of Si addition on the microstructures, mechanical properties and helium irradiation resistance of the NiCoCr-based alloys. The microstructures and the phase evolution of these alloys were examined using electron microscopy as well as the existing models. The results show that the alloys exhibit a single face-centered-cubic structure when the Si content is in the range of 0–6.25 at. %, whereas phase decomposition occurs as the Si content further increases (∼9 at. %). Comparing with NiCoCr, NiCoCrSi_0.2 exhibited improved strength without sacrificing the ductility. The yield strength and ultimate tensile strength increased from 438 to 599 MPa and 921–1032 MPa, respectively, whilst the ductility kept as high as ∼50%. Our analysis indicates that the increased strength is mainly ascribed to the grain boundary strengthening. The large ductility is primarily due to the low stacking fault energy and shear modulus of the NiCoCrSi_0.2 alloy, which makes mechanical twinning in small grains accessible and provides a steady strain-hardening rate in a wide strain regime. Besides, the enhanced compositional complexity and local lattice distortion induced by the introduction of Si can improve the helium irradiation resistance of NiCoCr, resulting in reduced average bubble size.</p>

materials science, multidisciplinary,chemistry, physical,metallurgy & metallurgical engineering