High-Efficiency Ultrasound Energy Harvesting Interface with Auto-Calibrated Timing Control from $-$ 25 $^{\circ}$ C to 85 $^{\circ}$ C

Guangshu Zhao,Chao Xie,Chenxi Wang,Milin Zhang,Man-Kay Law

DOI: https://doi.org/10.1109/jssc.2024.3506781

IF: 5.4

2024-01-01

IEEE Journal of Solid-State Circuits

Abstract:This work presents a high-efficiency ultrasound energy harvesting interface with auto-calibrated timing control, featuring: 1) the proposed $C_{\text{P}}$ auto-calibration, consisting of the half bias-flip time ( $t_{\text{half}}$ ) detection and adaptive closed-loop time calibration (ACTC) to improve the system’s robustness against piezoelectric transducer (PZT) materials and environmental variations; 2) the proposed charge recycling (CR) bootstrapping driver to reduce conduction loss and improve the $C_{\text{P}}$ auto-calibration accuracy as well as the peak voltage flipping efficiency ( $\eta_{\text{flip}}$ ); and 3) the proposed coarse detection and fine calibration technique to eliminate the inherent timing offset and increase the acceptable input excitation frequency range. The fabricated chip prototype in 0.18- $\mu$ m silicon on insulator (SOI) CMOS process can adapt to both PZT5A (nominal $C_{\text{P}}$ $\sim$ 114 pF) and PZT5H (nominal $C_{\text{P}}$ $\sim$ 190 pF) and is capable of operating over a wide temperature range from $-$ 25 $^{\circ}$ C to 85 $^{\circ}$ C. The proposed $C_{\text{P}}$ auto-calibration and CR bootstrapping driver can improve the $\eta_{\text{flip}}$ to as high as 93.6% at an output power of 496.6 $\mu$ W. With the proposed coarse detection and fine calibration technique, this work demonstrates a high measured peak power conversion efficiency (PCE) of 94.5%, corresponding to a $\sim$ 23% improvement when compared with the prior ultrasound energy harvesting interface while achieving a favorable figure of merit (FoM) of 8.13 $\times$ .