Abstract:The unique mechanical and physical properties of eutectic high entropy alloys (EHEAs) have attracted increasing attention and research interest in design and development of new advanced materials. However, the relatively high content of Co element in those commonly reported EHEAs based on 1st transition series elements leads to relatively high cost of bulk production and significantly restricts potential applications. Thus, study on development and application of EHEAs without Co addition is essential. In the current work, a novel solid self-lubricating composite has been successfully fabricated by mechanical alloying (MA) and subsequent spark plasma sintering (SPS) processes using the cost-effective Co-free EHEA, Al0.8CrFeNi2.2, as matrix. Its microstructure and phase constitutions were examined by SEM, TEM and XRD techniques, and its mechanical properties were evaluated by Vickers hardness test and compression test. The EHEA-Ag composite exhibited a Vickers hardness of 400 HV, a yield strength of 1136.5 MPa, and an ultimate strength of 1232.9 MPa, respectively. Moreover, its wear properties were investigated in a wide temperature range from room temperature to 900 °C by sliding against silicon nitride Si3N4 balls. Similar friction coefficients of EHEA-Ag were obtained in the studied temperature range. However, the wear rate of EHEA-Ag was found to decrease first when the sliding temperature was lower than 600 °C and then increased significantly when it was increased from 600 to 900 °C. A similar tendency in wear rate was observed during the sliding wear of EHEA matrix, but the comparison revealed a much lower wear rate of EHEA than EHEA-Ag at 900 °C. EHEA-Ag and EHEA exhibit different wear mechanisms at room temperature but the same wear mechanisms when the temperature is higher than 600 °C. The outcome of this study indicates that EHEA-Ag can act as an excellent solid self-lubricating composite candidate in a temperature range from RT to 600 °C.

A Novel CoCrNi-based Medium-Entropy Alloy Self-Lubricating Composite with Superior Wear Performance

Excellent Tribological Performance at Elevated Temperatures and Associated Mechanisms of Novel AlCoCrFeNi-MoS2 Solid Self-Lubricating Composite

Study on Tribological Performance of the Cocrni-Doped Sic Self-Lubricating Composites under Dry and Lubricated Conditions

Achieving Excellent Mechanical and Robust Lubrication Behavior in the CoCrNi Medium-Entropy Alloy Via In-Situ Graphite

A novel CoCrNi/W/Agx medium-entropy alloy matrix composite reinforced by Ag nanoparticle and self-lubricating mechanism under ambient air and high vacuum conditions

Significantly Lowering Friction and Wear of CoCrNi Medium-Entropy Alloy Film Via Massive Interstitial Carbon-Induced Amorphization

Synergetic Enhancements on the Mechanical and Tribological Performance of Al10Cr17Fe20NiV4 Medium‐Entropy Alloys Induced by Nano‐Al2O3 Particles

An atomic insight into the stoichiometry effect on the tribological behaviors of CrCoNi medium-entropy alloy

Microstructure, Mechanical and Tribological Properties of Al0.3CrFeNiTi0.3-CaF2/BaF2 Self-Lubricating Composite Fabricated by Spark Plasma Sintering

Robust wear performance of graphene-reinforced high entropy alloy composites

Microstructure and Tribological Performance of Fe50Mn30Co10Cr10 High-Entropy Alloy Based Self-Lubricating Composites

Mechanical and Dry Sliding Tribological Properties of CoCrNiNbx Medium-Entropy Alloys at Room Temperature

Tribological performance of a cost-effective CrFeNiAl0.3Ti0.3 high entropy alloy based self-lubricating composite in a wide temperature range

Preparation and Wear Performance of Novel Graphite/Copper Alloy-Matrix Self-Lubricating Composite Materials

Micro-structures and Dry Sliding Wear Properties of Novel AlCrFeNiMo0.5-x(WC) High Entropy Alloy-Ceramic Composite Coatings

Mechanical and dry sliding tribological properties of CoCrNiNb medium-entropy alloys at room temperature

Optimized wear behaviors and related wear mechanisms of medium entropy alloy-based composite coatings

Fabrication and characterization of a low-cost Co-free Al0.8CrFeNi2.2 eutectic high entropy alloy based solid self-lubricating composite: Microstructure, mechanical and wear properties

An exceptionally wear-resistant CoFeNi 2 medium entropy alloy via tribo-induced nanocrystallites with amorphous boundaries

Microstructure characterization and robust lubrication performance of CoCrNi medium entropy alloy with advanced electrochemical boronizing treatment

A Wear-Resistant Metastable CoCrNiCu High-Entropy Alloy with Modulated Surface and Subsurface Structures