Abstract:The damage status of Ni-based single crystal alloy determines its remaining service life. However, the study of the damage status of Ni-based single crystal alloy in the early service stage has not been reported. Therefore, this paper will establish a theoretical relationship that reflects the interaction between the microstructure evolution of Ni-based single crystal alloy and the Lamb wave. Micro-defects of different specifications and sizes are actively produced by laser cratering on the surface of the Ni-based single crystal alloy. Then the prepared samples with different damage levels are experimentally measured, and the damage statuses of these samples are quantitatively characterized by nonlinear parameter. Finally, the molecular dynamics method is used to quantitatively calculate the dislocation density, dislocation chord length and stress of Ni-based single crystal alloy. Through experimental measurements, it can be observed that in the early damage stage of the Ni-based single crystal alloy, the second harmonic amplitude and nonlinear characteristic parameter enlarge with the increase of the micropit diameter. Molecular dynamics simulation can reveal the variation and cause of the second harmonic amplitude and nonlinear characteristic parameter. Moreover, it is found that with the increase of micropit depth, the corresponding second harmonic amplitude and nonlinear characteristic parameter become larger. And under the same micropit depth, the corresponding second harmonic amplitude and nonlinear characteristic parameter become larger with the increase of micropit diameter, which is consistent with the experimental results. The above research results fully indicate that the second harmonic amplitude and nonlinear characteristic parameter change with the degree of damage intensification, which can provide a theoretical basis for the prediction of remaining service life of Ni-based single crystal alloy in the early stage.

Nanosecond Laser Ablation of Micro-pits in Ni60/WC Coatings with Coupled Thermal-stress Simulation and Parameter Optimization

INTEGRATED TECHNOLOGY FOR DETECTION AND REPAIR OF MECHANICAL COMPONENT SURFACE FATIGUE MICROCRACKS USING PULSED LASER

Optimization of Laser Repair Parameters for Precracked 304 Stainless Steel Components with Nanocomposites Addition

Investigation of Microhole Quality of Nickel-Based Single Crystal Superalloy Processed by Ultrafast Laser

Multi-objective Numerical Simulation of Geometrical Characteristics of Laser Cladding of Cobalt-Based Alloy Based on Response Surface Methodology

Effect of Laser Parameters on Fracture Properties of Laser-Repaired Cracks with Micro/NanoMaterial Addition: Multiscale Analysis

Optimization of Laser Glazing Parameters for Reduction of Residual-Stress

Optimization of Nanosecond Laser Processing for Microgroove on TC4 Surface by Combining Response Surface Method and Genetic Algorithm

Stepwise varying of laser parameters to enhance the residual stress field in multiple laser shock processing: numerical verification of single-point region

Nanosecond Laser Processing for Improving the Surface Characteristics of Silicon Wafers Cut Using Wire Electrical Discharge Machining

Design and experiment for a numerical control nanosecond water-jet-guided laser processing test bench

Research on the interaction between surface laser-pit of Ni-based single crystal alloy and lamb wave under micro-conditions

Topographic analysis of holes drilled by ultrahigh intensity nanosecond UV laser

Nanosecond UV laser induced subsurface damage mechanics of cemented tungsten carbide

Laser processing characteristics of PCD tool and modeling analysis

Mechanism and Performance Characterization of Heat Treatment on Laser-Cladded Ni-WC Coatings

Parameter Optimization and the Effects on Crack Trend in Pulsed Laser Surface Treated Cast Iron

Design and Optimization of Interface Morphology of Thermal Barrier Coatings Based on Regulation of Residual Stress: A Finite Element Simulation Study

Research on process optimization and microstructure of CrCoNi medium-entropy alloy formed by laser metal deposition

Process Optimization of Laser Cladding Ni60A Alloy Coating in Remanufacturing