Abstract:Abstract The tandem cascade can be used as an efficient way to improve the compressor load. As for the interaction parameters between two rows of the tandem diffuser, it is known that the relative circumferential position, radial gap between two rows, ratio of chord length of two rows, difference of the stagger angle between the front row and rear row blades have significant impact on the performance of the tandem cascade diffuser. In the literature, there is a lack of references for evaluating quantitatively the influence of important tandem design parameters on the tandem diffuser, and thus the adjustment ranges of the tandem parameters cannot be determined accurately. In order to investigate the influences of the tandem design parameters on the compressor performance, in an economically affordable manner, the influences of the design parameters for the tandem cascades diffuser were investigated by Design of Experiments (DOE) method. The orthogonal experimental designs are performed for the radial gap R between the front row and rear row, inlet stagger angle θ of the rear row and relative circumferential position L between the front row and rear row of the tandem diffuser. The DOE analysis results demonstrate that the inlet stagger angle θ of the rear row has significant influence on the response value of total pressure ratio and isentropic efficiency. The relationship between the design parameters of the tandem diffuser and the compressor performance is obtained from the DOE method. The design parameters are adjusted and determined according to the DOE analysis, and then the validation calculations are carried out. The parameter selection capacity of DOE method has been validated by the results. The design parameters determined from DOE analysis can be effectively used in the design process of the tandem diffuser, with notably reduced amount of simulation of each parameter.

Multi-Objective Design Optimization of a Dump Diffuser with Wide Speed Range

A throughflow-based optimization method for multi-stage axial compressor

Multi-Point Optimization on the Diffuser of an Axial Flow Pump

Parameter Optimization of Combustor Dump Diffuser Based on RSM

A Fast Multiobjective Optimization Approach to S-duct Scoop Inlets Design with Both Inflow and Outflow

Multi-Objective Aerodynamic Optimization of Gas Turbine Exhaust Diffuser: Experimental and Numerical Validations

Performance Improvement of a Centrifugal Compressor by a Variable Low Solidity Diffuser

CENTRIFUGAL COMPRESSOR DESIGN SYSTEM BASED ON MULTIDISCIPLINARY DESIGN OPTIMIZATION

Fast Multi-Objective Optimization Design of Gas Turbine L-inlet Duct

Performance Improvement of a High Loading Centrifugal Compressor with Vaned Diffuser by Hub Contour Optimization

A Combinatorial Optimization Design Method Applied to S-shaped Compressor Transition Duct Design

Multi-objective optimization study on the power cooling performance and the cooling drag of a full-scale vehicle

Coupling-looseness multidisciplinary design optimization of centrifugal compressor

Investigation on Influence of Design Parameters for Tandem Cascades Diffuser Using DOE Method

The Optimization of A Low Specific Speed Pipeline Pump

Preliminary Design of Centrifugal Compressor Using Multidisciplinary Optimization Method

Multidisciplinary Design and Multi-Objective Optimization on Guide Fins of Twin-Web Disk Using Kriging Surrogate Model

Adaptive Flow Optimization of a Turbocharger Compressor to Improve Engine Low Speed Performance

Prescreening Surrogate-Model-assisted Multi-Objective Aerodynamic Optimization Design of Highly Loaded Axial Compressor in Heavy-Duty Gas Turbine

Multidisciplinary Design Optimization with Multiple Degrees of Freedom for an Axial Compressor Based on Data-Driven

Aerodynamic Optimization Design and Experimental Verification of a High-Load Axial Flow Compressor