Abstract:High-precision microelectromechanical system (MEMS) accelerometers have wide application in the military and civil fields. The closed-loop microaccelerometer interface circuit with switched capacitor topology has a high signal-to-noise ratio, wide bandwidth, good linearity, and easy implementation in complementary metal oxide semiconductor (CMOS) process. Aiming at the urgent need for high-precision MEMS accelerometers in geophones, we carried out relevant research on high-performance closed-loop application specific integrated circuit (ASIC) chips. According to the characteristics of the performance parameters and output signal of MEMS accelerometers used in geophones, a high-precision closed-loop interface ASIC chip based on electrostatic time-multiplexing feedback technology and proportion integration differentiation (PID) feedback control technology was designed and implemented. The interface circuit consisted of a low-noise charge-sensitive amplifier (CSA), a sampling and holding circuit, and a PID feedback circuit. We analyzed and optimized the noise characteristics of the interface circuit and used a capacitance compensation array method to eliminate misalignment of the sensitive element. The correlated double sampling (CDS) technology was used to eliminate low-frequency noise and offset of the interface circuit. The layout design and engineering batch chip were fabricated by a standard 0.35 μm CMOS process. The active area of the chip was 3.2 mm × 3 mm. We tested the performance of the accelerometer system with the following conditions: power dissipation of 7.7 mW with a 5 V power supply and noise density less than 0.5 μg/Hz1/2. The accelerometers had a sensitivity of 1.2 V/g and an input range of ±1.2 g. The nonlinearity was 0.15%, and the bias instability was about 50 μg.

Design of an Acceleration ASIC for Real-Time Integrated Navigation System

An Intelligent and Acceleration ASIC Design for High Precision Positioning and Posture Surveillance System.

The Integrated Navigation System of Auv "Xuanwu"

Velocity and Position Calculation ASIC Design Based on Strapdown Inertial Navigation Algorithm

Field Programmable Gate Array Based Parallel Strapdown Algorithm Design for Strapdown Inertial Navigation Systems

Design and Application Space Exploration of a Domain-Specific Accelerator System

A High-Performance Chip with Dataflow Architecture for Attitude and Heading Reference System Accelerating

Efficient Hardware Accelerator Design of Non-Linear Optimization Correlative Scan Matching Algorithm in 2D LiDAR SLAM for Mobile Robots

A Novel Single Chip Implementation of MEMS INS Data Acquisition and Processing System Using FPGA and Its Soft Processors

Co-design of a novel CMOS highly parallel, low-power, multi-chip neural network accelerator

Hardware Acceleration for SLAM in Mobile Systems

Real-Time Spaceborne Synthetic Aperture Radar Float-Point Imaging System Using Optimized Mapping Methodology and a Multi-Node Parallel Accelerating Technique

THE IMPLEMENT OF SPEED ESTIMATION CORE BASED ON MRAS ALGORITHM

A Reconfigurable Visual-Inertial Odometry Accelerated Core with High Area and Energy Efficiency for Autonomous Mobile Robots

A 40nm 2TOPS/W Depth-Completion Neural Network Accelerator SoC With Efficient Depth Engine for Realtime LiDAR Systems

Real-Time Visual Inertial Odometry with a Resource-Efficient Harris Corner Detection Accelerator on FPGA Platform

Research on High-Resolution Miniaturized MEMS Accelerometer Interface ASIC

Miniaturization Design of High-Integration Unmanned Aerial Vehicle-Borne Video Synthetic Aperture Radar Real-Time Imaging Processing Component

Co-Exploration of Neural Architectures and Heterogeneous ASIC Accelerator Designs Targeting Multiple Tasks

Hardware Software Co-Design Based Reconfigurable Radar Signal Processing Accelerator for Joint Radar-Communication System

Exploiting Real-Time FPGA Based Adaptive Systems Technology for Real-Time Sensor Fusion in Next Generation Automotive Safety Systems