Abstract:Biomass pyrolysis by solid heat carrier is regarded to be efficient in heat transfer, high in tar yield and easier for reactor scale-up. However the transient behaviors in heat and mass transfer and complicate reactions, especially the volatiles reaction in the solid heat carrier phase, make it difficult to understand the relations between operating conditions and the conditions of actual reactions, and consequently the yield and composition of the products. This work studies these relations using a 4 mm layer of walnut shell as the biomass and some amounts of quartz sand as the solid heat carrier in a specially designed small reactor to simulate a finite element in a moving bed large reactor. The mean temperature of the walnut shell layer (<math>T-</math>WS) and the highest temperature of the quartz sand layer (<math>T-</math>QS-o) under various quartz sand preheating temperatures (PT, 600–900 °C) and various solid heat carrier-to-biomass mass ratios (Rs-b, 5:1–9:1) are determined and correlated with the walnut shell pyrolysis and volatiles reaction. The results show that <math>T-</math>QS-o and <math>T-</math>WS depend linearly on PT and Rs-b, but their difference varies from 39 to 108 °C. A reaction matrix is proposed and the oil yield is modeled by first order kinetics which decouples the roles of <math>T-</math>WS in WS pyrolysis and <math>T-</math>QS-o in oil reaction. It is found that the walnut shell pyrolysis is strongly influenced by heat transfer from quartz sand to walnut shell with activation energy of only 46.4 or 19.2 kJ/mol for varying PT or Rs-b, respectively. The oil reaction in the quartz sand layer reduces the oil yield and is dominated by the reaction of radical fragments that is weakly dependent on temperature, so the activation energy is also low, 4.8 or 2.9 kJ/mol for varying PT or Rs-b, respectively. The oil reaction in the quartz sand is extensive and more than 50% of it is converted to non-oil volatiles at <math>T-</math>WS of 350 °C.

Heat Transfer Characteristics of Micro-Droplet Impacting on High-Temperature Wall in Pyrolysis of Methyl Ricinoleate

Methyl ricinoleate droplet impact on a high temperature stainless steel surface: Dynamic behavior and heat transfer

Three-dimensional Simulation of a Novel Microwave-Assisted Heating Device for Methyl Ricinoleate Pyrolysis

Fast Pyrolysis of Methyl Ricinoleate in an Inductively Heated Reactor Coupled with Atomization Feeding

Pyrolysis of Methyl Ricinoleate by Microwave-Assisted Heating Coupled with Atomization Feeding

Collision Characterization of Mixed Hydrocarbon Liquid Droplets with Polyethylene Particles

Predictive Models for Characterizing the Atomization Process in Pyrolysis of Methyl Ricinoleate

Mass Transfer Characterization for Hydrocarbon Liquid–particle Collision Based on Sensitive Tracing of Fluorescent Probe

Pyrolysis of Methyl Ricinoleate: Distribution and Characteristics of Fast and Slow Pyrolysis Products

Experimental Study on Reactor Scale-Up for Microwave-Assisted Pyrolysis of Methyl Ricinoleate

Analytical analysis of non-boiling heat transfer during droplet impact on heated wall and the effect of thermophysical properties

Simplification of Pyrolytic Reaction Mechanism and Turbulent Heat Transfer of N-Decane at Supercritical Pressures

Supercritical-Pressure Heat Transfer, Pyrolytic Reactions, and Surface Coking of N-Decane in Helical Tubes

Effect of pyrolytic reaction of supercritical aviation kerosene RP-3 on heat and mass transfer in the near-wall region

Heat Transfer in a Novel Microwave Heating Device Coupled with Atomization Feeding

Experimental Study on a Water Droplet Impacting on the Heated Glycerol Surface

Molecular dynamics simulation of nanodroplet impacting on high-temperature plate wall

Study of temperature variation of walnut shell and solid heat carrier and their effect on primary pyrolysis and volatiles reaction

Heat Transfer Inside Particles and Devolatilization for Coal Pyrolysis to Acetylene at Ultrahigh Temperatures

Numerical simulation of heat transfer properties of large-sized biomass particles during pyrolysis process

Experimental study on the collision behaviors of micron-sized aluminum droplets with solid wall in high temperature burned gas