Abstract:NHR200-II is a 200 MW nuclear heating reactor. The integrity of the fuel assembly should be ensured during the normal operations and design basis accidents. In the latter cases (e.g. earthquake), its deformation or damage should not prevent the insertion of control rods to shut down the reactor. Meanwhile, during the operating time, there are two aspects that attention should be paid, (i) the mechanical performance of internal core materials might be worsened by the increase of burnup and (ii) dynamic loads involving hydraulic erosion, flow-induced vibration might damage the assemblies. Therefore, the investigation of the dynamic characteristics of the fuel assembly with consideration of burnup effects is necessary. The fuel rod with pellets and cladding was approximated by the beam elements with a circular cross-section applied with calibrated material properties. Connector elements were used to replace the three-arc springs and dimples on the grid and thus simplify the geometry of the spacer grid. The agreements between the detailed and simplified models indicate the equivalence of these two methods. Then two simulations were performed to evaluate the dynamic characteristics of NHR200-II fuel assembly at the beginning of life. The modal simulation of the fuel bundle and channel suggests that the channel could be assumed stationary to the fuel bundle during the dynamic analysis. The seismic simulation conducted in the specific boundary conditions indicates that the integrity of spacer grids can be guaranteed and there was no buckling of the gird. No permanent deformation of the channel was observed, and its relative displacements were sufficiently small to ensure the insertion of control rods. Finally, burnup effects on the structural behavior of the fuel rod are discussed. The initial conditions of NHR200-II fuel assembly and its material properties at different burnup times are provided by referring to two irradiated tests. Various sensitivity analyses had been conducted to evaluate the effects of material properties and pellet-cladding interaction on the resulting failure limit and stiffness of the fuel rod.

An Iterational Physical Decoupling Method for Assessing the Safety of Deformed Fuel Channels

Study on safety gap between fuel channels in NHR200-II

Numerical Investigation on Effects of Fuel Rod with Different Bow Deformation Ratio X on Two-Phase Boiling and Flow Performances of Coolant in Fuel Assembly

A Particle Finite Element Method Based Partitioned Paradigm for the Axial-Flow-induced Vibration Analysis of NHR200-II Fuel Rod

Numerical Simulation Analysis of Debris Filtration in the Bottom Nozzle

Thermal-fluid-structure Coupling Analysis for Plate-Type Fuel Assembly under Irradiation. Part-I Numerical Methodology

Thermal and Mechanics Analysis Code of the PWR Nuclear Fuel Performance Based on FEM

Simulation of Dynamic Characteristics of NHR200-II Fuel Assembly

Numerical Simulation Investigations on the Flow Induced Vibration of a Nuclear Fuel Rod with Relaxed Clamping Structures

3D Fluid-Solid Coupling Simulation for Plate-Type Nuclear Fuel Assemblies under the Irradiation Condition

Prediction of critical heat flux in rod bowing geometries by coupled subchannel analysis and mechanistic model

Numerical Simulation of Fuel Relocation at High Burnup with Discrete Element Method

3-Dimensional Multiphysics Modeling of Behaviors of Pressurized Water Reactor Fuel Rods With Missing Pellet Surface

Numerical investigation on effects of fuel rod with different shapes of bow deformation on the subcooled boiling of coolant in a fuel assembly

Study on the Effect of Flow Blockage Due to Rod Deformation in QUENCH Experiment

Flow Distribution Characteristics of Parallel Narrow Rectangular Channels under Deformation Conditions -Part II: Numerical Model

Numerical simulation for the control rod assembly drop time evaluation in a LFR

Numerical Simulation and Validation of Flow-Induced Vibration of the Specific Rod under Elastic Supports using One-Way Fluid-Solid Interaction

Numerical Simulation of Pressure Force for Control Rod Guide Tube in PWR

Experimental and Numerical Study on the Oxidation and Melting Behaviors of Annular Fuel Rod under High Temperature Steam Condition

Advanced CFD modeling of rod bundle channels with integrated porous media and momentum source schemes