Abstract:During the landing and recycling on the sea surface of a spacecraft or rocket, a concave structure may impact on the water surface. In the present paper, we experimentally and numerically analyze the multiphase flows and transient impact load during the oblique water entry of the concave-nose projectile. The projectiles used in the experiments consist of a main body that embeds an acceleration measurement system, and a transparent concave-nose. Firstly, free surface evolutions and cavity dynamics are given for the concave-nose projectile, which shows significant changes compared with the projectile without concave-nose. A special jet inside the concave-nose during the formation of the air-entertainment cavity is observed. Subsequently, it is found that compared with the projectile without concave-nose in the early stage. The increase rate of the axial force of the concave-nose projectile is slower and the force curve has a steep drop stage, then they enter the uniform reduction stage. As the concave depth increases, a 'double-peak' phenomenon on the axial force curve appears. It is found that the force peak is transferred to a single peak with increasing the impact velocity. The force peak of the concave-nose projectile is greater than the projectile without concave-nose. Besides, with increasing the concave depth, the maximum axial force of the concave-nose projectile increases firstly, and then decreases. When the ratio of concave depth to inner diameter is greater than 2, the influence of concave depth on the peak value of axial force is small. Moreover, the pressure distributions of the fluid domain and the concave-nose are analyzed to reveal the mechanism of the variation of the force peak. The study is able to provide a basic reference for the analysis of the recycling of the rocket, aircraft, etc.

Impact Load Characteristics of Large-Scale Trans-Medium Vehicles During High-Speed Oblique Water Entry

Exploring the load characteristics and structural responses of a high-speed vehicle entering water

Multiphase Flow Simulation of Water Entry of a Structure with Complex Geometry Using a Three-Dimensional Parallel Compressible Model

Formulations of Hydrodynamic Force in the Transition Stage of the Water Entry of Linear Wedges with Constant and Varying Speeds

Research on Hydrodynamics of Trans-Media Vehicles Considering Underwater Time-Varying Attitudes

Numerical study on the dynamic characteristics of a vehicle with a multistage load reduction structure during oblique water entry

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Numerical Study of Violent Impact Flow Using a CIP-Based Model

Numerical analysis of cavitation and impact load characteristics of supercavitating vehicle entering water at high speed

Numerical study of hydrodynamic loads at early stage of vertical high-speed water entry of an axisymmetric blunt body

Green Water Loading on a Floating Structure with Degree of Freedom Effects

Simulation and experimental research on trans-media vehicle water-entry motion characteristics at low speed

Numerical Simulation of the Horizontal Water-Entry Process of High-Speed Vehicles

Dynamics analysis of high-speed water entry of axisymmetric body using fluid-structure-acoustic coupling method

Experimental investigation on the slamming loads of a truncated 3D stern model entering into water

Experimental Study and Numerical Simulation of the Water Entry of a Ship-Like Symmetry Section with an Obvious Bulbous Bow

Load and motion behaviors of ogive-nosed projectile during high-speed water entry with angle of attack

Symmetrical and asymmetrical water entry of a three-dimensional bow-flared section by a Cartesian grid multiphase flow model with multiple DOF motion

Numerical Study of Flat Plate Impact on Water Using a Compressible CIP–IBM–Based Model

Experimental and numerical investigations on the transient impact load of the oblique water entry of the concave-nose projectiles

Numerical simulation of subsonic and transonic water entry with compressibility effect considered