Abstract:This paper proposes a novel fault‐tolerant direct torque and flux control (DTFC) strategy to restrain fluctuating torque and enhance the torque dynamic performance of a five‐phase PMSM with open‐circuit fault. The decoupling control of torque and stator flux can be achieved under the open‐circuit fault condition, and the third harmonic current can be restrained without additional control. Multiphase permanent magnet synchronous motors (PMSMs) have attracted much more attention for their high efficiency, low torque ripple and good fault tolerance. However, open‐circuit fault results in asymmetrical motor behaviour, and deteriorates torque performance, especially dynamic response. This paper proposes a novel fault‐tolerant direct torque and flux control (DTFC) strategy to restrain fluctuating torque and enhance torque dynamic performance of a five‐phase PMSM with open‐circuit fault. The novelty of the proposed strategy is the development of DTFC based on stator flux orientation under the open‐circuit fault condition and the third harmonic current suppression with carrier‐based pulse width modulation technology. Consequently, the decoupling control of torque and stator flux can be achieved under the open‐circuit fault condition, and the third harmonic current can be restrained without additional control. Combined with deadbeat control, the heavy computation burden can be reduced. Thus, the proposed strategy not only can enhance torque dynamic performance under open‐circuit fault operation, but also keep smooth torque with circular stator flux trajectory before and after open‐circuit fault. The effectiveness of the proposed strategy is verified by the simulation and experimental results.

Multi-Harmonic Torque Ripple Optimization in Phase Current Reconstructed OW-PMSM Drive with Single-Phase Open-Circuit Fault

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Torque Ripple Suppression Control for Dual Three-Phase Permanent-Magnet Synchronous Motor

Adaptive Torque Ripple Suppression Methods of Three-Phase PMSM During Single-Phase Open-Circuit Fault-Tolerant Operation

Harmonic Model and Remedy Strategy of Multiphase PM Motor under Open-Circuit Fault

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Fault Tolerant Control of Harmonic Injected Nine-Phase Flux Switching Permanent Magnet Motor Drive System

Modeling and Control for Open-Winding PMSM Under Open-Phase Fault Based on New Coordinate Transformations

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions

Compatible Phase Current Reconstruction Scheme for Fault-Tolerant Five-Leg Dual-Inverter Fed Open–Winding Permanent Magnet Synchronous Motor

Torque dynamic performance enhancement of five‐phase permanent magnet synchronous motor with open‐circuit fault

Torque Ripple Suppression under Open-Circuit Fault for DTPPMSM Considering Back EMF Harmonics

Open-Circuit Fault-Tolerant Control for Dual Three-Phase PMSM with Minimum Torque Ripple Considering Phase Back EMF Harmonics

Torque Ripple Suppression Under Open-Phase Fault Conditions in a Five-Phase Induction Motor With Harmonic Injection

Inverter Reconstruction Approach for Open-End Winding Five-Phase PMSM With Pattern-Based Vector Synthesis and Hybrid SVPWM Modulation

Harmonic Torque Suppression Methods for Single-Phase Open-Circuit Fault-Tolerant Operation of PMSM Considering Third Harmonic BEMF

Fault-Tolerant Control of Dual-Three-Phase PMSM under Open-Phase Fault Based on Two-Individual Current Control

Optimized Fault-Tolerant Control of Dual Three-Phase PMSM Under Open-Switch Faults

On winding reconstruction method for six-phase motor with single-phase winding open-circuit faults