Abstract:A chip-on-board (COB) packaged four-channel optical receiver integrated with a transimpedance amplifier (TIA) in 0.13-μm SiGe-BiCMOS technology with f T /f MAX =260/350 GHz demonstrating 56-Gbaud four-level pulse-amplitude modulation (PAM-4) with low noise and high linearity is presented in support of optical receivers required in linear-drive pluggable optics (LPO) and beyond-400G optical links. The proposed four-stage optical receiver comprises an inductive shunt-feedback TIA followed by two variable gain amplifiers (VGAs) with a continuous-time linear equalizer (CTLE) function and a 50-ohm output buffer. The π-topology L-C network and inductive shunt feedback techniques are used in TIA to meet the specifications of wide bandwidth (BW) and low noise. Two current-splitting VGA stages with CTLE function cascaded after TIA featuring high reliability can compensate for the loss of BW which caused by photo diode (PD) parasitic capacitance and provide a gain control range of -12dB ~ +18dB that accommodates input current up to 2mApp with low group delay variation. The 50-ohm output buffer with a T-coil and degeneration resistor achieves better output matching and high linearity. Measurement results show that TIA provides a maximum DC transimpedance gain (ZT) of 74 dBΩ while O/E.BW is beyond 40 GHz, the 50-ohm output buffer offers 580-mV output swing and PAM-4 electrical eye diagrams up to 56-Gbaud of optical receiver with PRBS31Q. The optical receiver achieves a sensitivity of − 9.7-dBm optical modulation amplitude (OMA) at pre-FEC BER limit of 2.4 × 10 -4 operating 56-Gbaud PAM-4 SSPRQ and consumes 720mW with a power supply of 3.3 V.

A 112-Gb/s PAM-4 Receiver with Ultra-Fine GainAdjustment CTLE and Novel Sample-and-Reset Slicer in 28-Nm CMOS

A 25gb/s 185mw PAM-4 Receiver with 4-Tap Adaptive DFE and Sampling Clock Optimization in 55nm CMOS

A 1.41-Pj/b 56-Gb/s PAM-4 Receiver Using Enhanced Transition Utilization CDR and Genetic Adaptation Algorithms in 7-Nm CMOS

A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery

A 40-Gb/s PAM-3 Receiver With Modified Summer-Merged Slicers and PRTS Checker

Design of 80-Gb/s PAM4 Wireline Receiver in 65-Nm CMOS Technology

A 60-Gb/s 1.2-pJ/bit 1/4-Rate PAM-4 Receiver With a Jitter Compensation CDR

A 40 Gbps PAM-4 Receiver with 12-Tap Direct Decision Feedback Equalizer Employing 1.5-Stage Slicers in 65-Nm CMOS

A 56-Gbps PAM-4 Wireline Receiver with 4-Tap Direct DFE Employing Dynamic CML Comparators in 65 Nm CMOS

A 4 X 56-Gbaud PAM-4 Optical Receiver Integrated with SiGe-BiCMOS TIA

A 720-Mvpp 224-Gb/s PAM4 Optical Receiver with Multiple Peaking Techniques in 130-Nm SiGe BiCMOS

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 44 Gbps PAM-4 Transmitter with Resistance Feedback 4:1 MUX in 65nm CMOS

A 2.29-Pj/b 112-Gb/s Wireline Transceiver with RX Four-Tap FFE for Medium-Reach Applications in 28-Nm CMOS

A 28/56 Gb/s NRZ/PAM-4 dual-mode transceiver with 1/4 rate reconfigurable 4-tap FFE and half-rate slicer in a 28-nm CMOS

A 112gb/S Low-Noise Pam-4 Linear Optical Receiver In 28nm Cmos

A 56-Gbps PAM4 Amplitude-Rectification-based Receiver with Threshold Adaptation and 1-Tap DFE.

Design Of 56 Gb/Spam4 Wire-Line Receiver With Ring Vco Based Cdr In A 65 Nm Cmos Technology

A 51gb/s, 320mw, PAM4 CDR with Baud-Rate Sampling for High-Speed Optical Interconnects

A 40-Gb/s PAM-4 Transmitter Using a 0.16-Pj/bit SST-CML-Hybrid (SCH) Output Driver and a Hybrid-Path 3-Tap FFE Scheme in 28-Nm CMOS.

A 40gb/s PAM4 Baud-Rate CDR with Equal-Slope Algorithm