Abstract:The self-sustained flapping of a three-dimensional flexible plate in a uniform viscous flow is numerically simulated with a fictitious domain method. The effects of the various non-dimensional control parameters including the Reynolds number, the density ratio, the dimensionless shear modulus, the length–thickness ratio, and the width–length ratio on the flapping of the plate are investigated. The results show that there exist two flapping modes: symmetrical and asymmetrical flapping about the centerline in the spanwise direction. Near the critical point a decrease in the plate width–length ratio, or the increase in the Reynolds number or the reduced velocity (a combination of the density ratio, the dimensionless shear modulus, and the length–thickness ratio) can make symmetric (or nearly symmetric) flapping become asymmetric. It is found that the flapping amplitude is mainly controlled by the density ratio and the dimensionless elastic modulus, while the frequency by the density ratio and the length–thickness ratio. In addition, the flapping amplitude and frequency are affected significantly by the confinement effect of the computational domain, and normally enhanced as the confinement effect becomes stronger. The effects of the plate width and the mass ratio (i.e., the ratio of the length–thickness and density ratios) on the critical reduced velocities are examined. The results indicate that when the fluid–plate mass ratio (or the plate length–thickness ratio) is relatively small there exist two significantly different critical velocities for the flapping instability, depending on the strength of initial plate deformation, a hysteresis phenomenon. No obvious hysteresis can be observed when the fluid–plate mass ratio (or the plate length–thickness ratio) is large.

Effects of the closed domain area on the dynamics of a closed flexible filament behind a rigid plate

The Effect of Slip Distribution on Flow Past a Circular Cylinder

Dynamics of Two-Dimensional Flow Around a Circular Cylinder with Flexible Filaments Attached

Dynamics of a rigid-flexible coupling system in a uniform flow

Experimental And Numerical Study Of Bubble Drag Reduction On A Flat Plate

Numerical simulations of the flapping of a three-dimensional flexible plate in uniform flow

Drag Force on a Free Surface-Piercing Yawed Circular Cylinder in Steady Flow

Simulations of passive oscillation of a flexible plate in the wake of a cylinder by immersed boundary method

Numerical Analysis of Turbulence Characteristics in a Flat-Plate Flow with Riblets Control

Boundary layer analysis of ventilated partial cavity for friction drag reduction

Drag reduction by flapping a pair of flexible filaments behind a cylinder

Effects of Lateral Space and Angle of Attack on Ventilated Partial Cavity

Symmetry breaking of a closed flexible filament behind a rigid plate at low Reynolds numbers

Stream-Wise Distribution of Skin-Friction Drag Reduction on A Flat Plate with Bubble Injection

Dynamics of Fluid Flow over A Circular Flexible Plate

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Numerical simulations of the flow past a perforated plate enclosed by a filament using the Immersed Boundary Method

The Influence of Advection Schemes and Turbulence Closure Models on Drag Coefficient Calculation Around a Circular Cylinder at High Reynolds Number

Experimental and Numerical Investigation on the Cavity Regime and Drag Reduction of Ventilated Partial Cavity

Vortex Induced Vibration of a Circular Cylinder with a Filament by Using Penalty Immersed Boundary Method

Effects of Localized Micro-blowing on a Spatially Developing Flat Turbulent Boundary Layer