An in Vitro and in Vivo Study of Biodegradable Zn-Cu-Li - Cu - Li Alloy with High Strength and Ductility Fabricated by Hot Extrusion Combined with Room-Temperature ECAP

Jingzhu Duan,Lei Li,Fanglin Cao,Yusong Suo,Qun Yang,Jingong Qin,Xiangjie Wang,Yang

DOI: https://doi.org/10.1016/j.jmrt.2024.10.110

2024-01-01

Abstract:Deformation processing is a commonly used strategy to improve the microstructure and hence mechanical properties of biodegradable Zn alloys. However, a single conventional processing method is usually limited in achieving this goal. In this work, hot extrusion combined with room-temperature equal channel angular pressing (ECAP) was used to fabricate biodegradable Zn-Cu-Li alloy. Compared to the hot-extruded alloy, the further ECAPed alloys have significantly finer Zn grains and precipitate more submicron- and nano-sized epsilon-CuZn4 particles. Moreover, the 4-pass as-ECAPed alloy exhibits the best comprehensive mechanical properties with yield strength of 315 +/- 3 MPa, ultimate tensile strength of 444 +/- 13 MPa and elongation of 81 +/- 5%, which are 13.3%, 38.8% and 72.3% higher than those of the hot-extruded alloy, respectively. In addition, in vitro and in vivo tests were performed on the 4-pass as-ECAPed alloy to evaluate its corrosion behavior, antibacterial property, cytotoxicity and biocompatibility. In vitro results showed that the 4-pass as-ECAPed alloy exhibits better corrosion resistance than the 8-pass alloy. Also, it shows good antibacterial property, hemocompatibility and cytocompatibility. In vivo results demonstrated that the 4-pass as-ECAPed alloy exhibits faster and more uniform degradation than the pure Zn (as a control group). Both the pure Zn and 4-pass as-ECAPed alloy promote formation of new bone, the mass of which increases over time. The 4-pass as-ECAPed alloy shows slightly weaker osteogenic capacity but better overall osteointegration than the pure Zn. Furthermore, both the pure Zn and 4pass as-ECAPed alloy exhibit good in vivo biosafety.