Abstract:As the most compute-intensive signal processing task in the global positioning system (GPS) receiver, signal acquisition accounts for most of the power budget, which is a key bottleneck in extending the battery life of edge devices. To improve the energy efficiency of GPS signal acquisition, we present charge-domain computing for GPS signal acquisition (CCSA), a matched filter with CCSA. It employs a 64 $\times$ 64 mixed-signal processing element (PE) array, a 2.8-b flash analog-to-digital converter (ADC), and a digital controller. Each PE handles the element-wise multiplication with a mixed-signal multiplier (MSMUL), which can perform the multiplication and digital-to-charge conversion simultaneously with a two-phase operation scheme. We develop the two-phase digital-to-charge mapping method for the MSMUL, where the digital multiplication result is converted into the charge difference stored in a capacitor between the charge reset phase and the charge evaluation phase. The charge-domain outputs of all MSMULs are dumped and redistributed on a global output wire for the accumulation operation. Compared to prior charge-domain works, the proposed design reduces the number of capacitors or additional voltage levels by half, thereby leading to better energy efficiency and lower circuit complexity. The 28-nm test chip achieves 114-394-TOPS/W energy efficiency across 0.34-0.9-V supply voltage, which is 8.2 $\times$ higher than state-of-the-art at the same throughput.

A 394-TOPS/W Matched Filter with Charge-Domain Computing for GPS Signal Acquisition

A New On-chip Signal Generator for Charge-Based Capacitance Measurement Circuit

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Low Power and High Speed Designs of CIC Filter for Sigma-Delta ADCs

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

A Fully Integrated Low-Power Multi-Mode RF Receiver for BDS-3/GPS

A 7.9 Μa Multi-Step Phase-Domain ADC for GFSK Demodulators

A low power triple-mode parallel-processing CMOS receiver for BD-II/GPS/Galileo joint navigation applications

A Dual-Channel Compass/GPS/GLONASS/Galileo Reconfigurable GNSS Receiver in 65 Nm CMOS with On-Chip I/Q Calibration.

A power-scalable reconfigurable active-RC complex band-pass filter for a multimode GNSS receiver

An Acquisition Circuit in Global Positioning System Receivers

A power-efficient 14-bit 250MS/s pipelined ADC

Adaptive Analog-to-Digital Converter for GPS Receiver

Charge-Domain Switched-G(M)-C Cbpf Using Semi-Passive Charge-Sharing Technique

Modeling and Improving the Energy Performance of GPS Receivers for Mobile Applications

A Dual-Channel GPS/Compass/Galileo/GLONASS Reconfigurable GNSS Receiver in 65nm CMOS

An 8 Bit 12 MS/s Asynchronous Successive Approximation Register ADC with an On-Chip Reference

Design and implementation of an optimized FIR filter for IF GPS signal simulator

Power-Scalable, Complex Bandpass/Low-Pass Filter With I/Q Imbalance Calibration for a Multimode GNSS Receiver

A 600 MHz-BW 154.3 Db-Fom Current-Mode Continuous-Time Pipelined ADC in 12 Nm CMOS

A Decimation Filter for High-speed ΣΔADC in LTE Protocol Application