Abstract:The recycling of lithium iron phosphate power batteries that have exploded in retirement is urgent, but the focus and difficulty of the recycling is the effective recovery of lithium and iron elements in the cathode active material. In this study, the cathode sheets and other components of the lithium-ion batteries were obtained by pretreatment, and the cathode active material and the Al foil of the collector were recovered by stirring with dilute alkali solution (optimized conditions of alkali solution concentration 0.075 mol L-1, liquid-solid ratio 20 mL g(-1), and stirring time 40 min). The H2SO4-H2O2 system was used to leach used lithium iron phosphate cathode powder, the leaching process conditions were optimized and the leaching mechanism was revealed. The leaching rates of Li and Fe elements reached 98.79 % and 94.97 %, respectively, at a H2SO4 concentration of 2.5 mol L-1, a H2O2 dosage of 6 mL, a liquid-solid ratio of 25 mL g(-1), a leaching temperature of 60 degrees C and a leaching time of 60 min. The pH value was precisely adjusted in the chemical precipitation method to recover lithium and iron elements from cathode active material. The recovered products FePO4 and Li2CO3 were used as the precursors for the regeneration of LiFePO4 cathode material. The electrochemical performance of LiFePO4/C materials regenerated at 700 degrees C from the raw material with a lithium to iron molar ratio of 1.03:1 was relatively good, with a first discharge specific capacity of 160.1 mAh g(-1) at 0.1 C, and a charge/discharge efficiency of 96.70 % for the first cycle. The good electrochemical performance was still maintained at a higher rate, with a capacity retention of 99.7 % after 100 cycles at 1 C.

Regenerating LiFePO4/C Using Recycled LiH2PO4 As Raw Material

Regeneration and Performance of LiFePO4 with Li2CO3 and FePO4 As Raw Materials Recovered from Spent LiFePO4 Batteries

Regenerated LiFePO4/C for scrapped lithium iron phosphate powder batteries by pre-oxidation and reduction method

A Facile Route for the Efficient Leaching, Recovery, and Regeneration of Lithium and Iron from Waste Lithium Iron Phosphate Cathode Materials

Regeneration of Black Powders of Waste Lithium Iron Phosphate Battery Produced by Large‐Scale Industrialization

Long‐Life Regenerated LiFePO4 from Spent Cathode by Elevating the d‐Band Center of Fe

Efficient Regeneration of Waste Lifepo4 Cathode Material by Short Process Low Temperature Plasma Assisted Nitrogen Doped Technology

Environmental-friendly low-cost direct regeneration of cathode material from spent LiFePO 4

Direct regeneration of spent LiFePO4 cathode material via a simple solid-phase method

Selective recovery of Li and FePO4 from spent LiFePO4 cathode scraps by organic acids and the properties of the regenerated LiFePO4

Closed-loop regeneration of LiFePO4 from spent lithium-ion batteries: A “feed three birds with one scone” strategy toward advanced cathode materials

A Method of Efficiently Regenerating Waste LiFePO4 Cathode Material after Air Firing Treatment

Direct Regeneration of High-Value LiFePO 4 Cathode Materials with Nitrogen Doped Carbon Coating

Regeneration of LiFePO4 from spent materials: control and influence of Al impurity

Direct regeneration of waste LiFePO4 cathode materials with a solid-phase method promoted by activated CNTs

Sustainable reprocessing of lithium iron phosphate batteries: A recovery approach using liquid-phase method at reduced temperature

A Room‐Temperature Lithium‐Restocking Strategy for the Direct Reuse of Degraded LiFePO4 Electrodes

Direct regeneration of spent LiFePO 4 materials via a green and economical one-step hydrothermal process

Direct regeneration of LiFePO4 cathode by inherent impurities in spent lithium-ion batteries

Electrochemical selective lithium extraction and regeneration of spent lithium iron phosphate

Revealing Lithium Configuration in Aged Layered Oxides for Effective Regeneration