Abstract:ABSTRACTCreep and saltation are the primary modes of surface transport involved in the fluid‐like movement of aeolian sands. Although numerous studies have focused on saltation, few studies have focused on creep, primarily because of the experimental difficulty and the limited amount of theoretical information available on this process. Grain size and its distribution characteristics are key controls on the modes of sand movement and their transport masses. Based on a series of wind tunnel experiments, this paper presents new data regarding the saltation flux, obtained using a flat sampler, and on the creeping mass, obtained using a specifically designed bed trap, associated with four friction velocities (0·41, 0·47, 0·55 and 0·61 m sec−1). These data yielded information regarding creeping and saltating sand grains and their particle size characteristics at various heights, which led to the following conclusions: (i) the creeping masses increased as a power function (q = −1·02 + 14·19u*3) of friction wind velocities, with a correlation (R2) of 0·95; (ii) the flux of aeolian sand flow decreases exponentially with increasing height (q = a exp(–z/b)) and increases as a power function (q = −26·30 + 428·40 u*3) of the friction wind velocity; (iii) the particle size of creeping sand grains is ca 1·15 times of the mean diameter of salting sand grains at a height of 0 to 2 cm, which is 1·14 times of the mean diameter of sand grains in a bed; and (iv) the mean diameter of saltating sand grains decreases rapidly with increasing height whereas, while at a given height, the mean diameter of saltating sand grains is positively correlated with the friction wind velocity. Although these results require additional experimental validation, they provide new information for modelling of aeolian sand transport processes.

A DEM Study on the Criteria for Particle Movement over a Granular Bed

Dem Applications to Aeolian Sediment Transport and Impact Process in Saltation

Computational Granular Dynamics Simulation of Unsteady Movement in Particle Moving Bed

A Theoretical Study of the Distribution of the Initial Velocity of Saltating Sand Particles by Collision

Particle Dynamics Method Simulations of Stochastic Collisions of Sandy Grain Bed with Mixed Size in Aeolian Sand Saltation

Investigation into the three-dimensional sand particle-bed collision process

Simulation of Dynamic Behavior of Saltation Grains from Loose Sedimentary Beds

Granular Pseudo-Fluid Large-Eddy Simulation Study of Aeolian Sand Transport Near a Bed Surface

Exploration of Probability Distribution of Velocities of Saltating Sand Particles Based on the Stochastic Particle–bed Collisions

Particle Velocity Distribution Based on the Three-Dimensional Stochastic Particle-Bed Collisions in Wind-Blown Sand Flux

Numerical investigation on two-grain-bed collisions in windblown sand transport

A Wind Tunnel Experiment Study on Splash Functions During Sand Saltation

Characterization of Wind‐blown Sand with Near‐wall Motions and Turbulence: from Grain‐scale Distributions to Sediment Transport

A Numerical Study of Aeolian Sand Particle Flow Incorporating Granular Pseudofluid Optimization and Large Eddy Simulation

The Numerical Simulation of Sand Particles Saltation

Statistical Analysis of Collision Between Saltation Particle and Bed Surface

DEM Simulation of the Particle Dynamics in Two-Dimensional Spouted Beds

Dem Simulation of Wet Granular-Fluid Flows in Spouted Beds: Numerical Studies and Experimental Verifications

Characteristics of Particle Size for Creeping and Saltating Sand Grains in Aeolian Transport

Splash Detail Due to Grain Incident on Granular Bed

Particle-scale kinematic model for the surface erosion of granular beds