Dehydrogenation of Methylcyclohexane over Layered Bimetallic Hydroxide-Derived Pt/Co-Al-O Catalysts

Wenchen Ren,Huanxi Wang,Qianlin Zhang,Mengchi Chen,Zhongrui Li,Huan Guo,Jing Bai,Xiaomin Dai,Santosh Kumar Verma,Yunhua Xu
DOI: https://doi.org/10.1016/j.ijhydene.2024.09.270
IF: 7.2
2024-01-01
International Journal of Hydrogen Energy
Abstract:In this paper, petal sheet layered Co-Al bimetallic hydroxides were prepared using the hydrothermal method using methanol as a solvent. Pt/Co-Al-O catalysts were produced after the impregnation method and H-2 reduction. This catalyst was applied to the dehydrogenation reaction process of methylcyclohexane to toluene. A fixed-bed reaction device carried out comparative tests of this series of catalysts, and the effect of Co addition on the performance of Pt/Co-Al-O catalysts was investigated in detail. Among them, the Pt/Co-3-Al-1-O catalyst showed the best performance with high toluene selectivity throughout the dehydrogenation process. The MCH conversion started to be greater than 90% at 330 degree celsius, and the hydrogenolysis rate was 262.7 mmol/g(Pt)/min. The conversion gradually increased with the reaction temperature, and the conversion could reach 99.5% at 410 degree celsius. The appropriate introduction of Co element can reduce the excessive strong acidic sites of Al2O3 itself and retain a certain number of weak acidic sites, while the bimetallic hydroxide carrier improves the dispersibility of the active component, reduces its particle size, and forms a certain strong interaction between the carrier and Pt. The final conversion of the catalyst decreased by about 2% in the 100 h stability test at 380 degree celsius, which indicated that the Pt/Co-3-Al-1-O catalyst had strong coking resistance and good stability. These results indicate that the Pt/Co-Al-O series catalysts have potential industrial applications in hydrogen energy utilization.
What problem does this paper attempt to address?