Abstract:Noise from rail transit viaducts often has a negative effect on surrounding buildings and nearby residents. To reduce the bridge vibration and radiated noise, floating slab tracks have been widely adopted in rail transit viaducts. To calculate the vibration of coupled track-bridge systems, both time-domain and frequency-domain methods can be applied although their relative performance is not very clear. This study aims to compare the two approaches and then provide some guidelines in choosing the appropriate method for predicting the vibration. The principle and methodology of the two calculation methods are firstly introduced, and the models for the train, floating slab track and bridge are developed using similar parameters. To further improve the efficiency and accuracy of the frequency-domain method, a half period method and a weighted average method are proposed to calculate the average responses of a certain point on the rail, floating slab and bridge to approximate the response during the pass-by. An indirect method is used to estimate the wheel–rail combined roughness from the measured rail acceleration when the train is running on the bridge, and compared with the direct measurement rail roughness. For the vibration of the bridge and floating slab, comparisons are made between results obtained from the time-domain and frequency-domain methods with different train speeds, and between results from experiment and simulation with different roughness. It is found that the wheel–rail contact forces and other structural responses from the two approaches show good consistency in the frequency region above 20 Hz. It is shown that a good approximation of the response during the pass-by can be obtained using the frequency-domain method by adopting the half period average or a simplified weighted average of two wheel position cases. When using the measured roughness and estimated roughness, the simulated vibration of the floating slab and bridge match well with the experimental results, and the indirect method can be used to modify direct measurement roughness in lower frequency regions. In the vibration prediction, the rail vibration or roughness, and other parameters in the vehicle–track–bridge system, should be measured accurately to ensure high reliability.

Comparative Analysis of Vibration and Noise Reduction Effect of Different Tracks on U-shaped Bridges

Analysis on Comfort of Lower Suspended Footbridge Caused by Traffic Load

Study on low-frequency noise radiated from steel multi-box girder bridge induced by traffic vibration

Theoretical analysis of low-frequency noise radiated from bridge vibrations

Comparison of vibration and noise characteristics of urban rail transit bridges with box-girder and U-shaped sections

Analysis on Low-Frequency Noise Induced by Vehicle-Bridge Coupling Vibration

Assessment on Transient Sound Radiation of a Vibrating Steel Bridge Due to Traffic Loading

Investigation of the effect of vibration-reducing tracks on the vibration and noise from a large-span steel bridge

Experimental noise and vibration characteristics of elevated urban rail transit considering the effect of track structures and noise barriers

Vibration Characteristics of Damping Pad Floating Slab on the Long-Span Steel Truss Cable-Stayed Bridge in Urban Rail Transit

Comparison of time-domain and frequency-domain models for vibration prediction of a rail transit viaduct paved with floating slab track

Vibro-acoustic characteristics of a rail transit viaduct paved with trapezoidal sleeper track

Effects of Steel Spring Floating Slab on Vibration and Noise of a Rail Transit Box-Girder

Analysis of the effect of combined noise reduction measures of trapezoidal sleeper and sound barrier on elevated line

Comparative analysis of track damping effect of structure jointly constructed by subway tunnels and high-rise buildings

Newly Constructed Subway on Over-Track Bridge Safety and Vibration Reduction Measure

Analysis of the Vibration Characteristics of Ballastless Track on Bridges Using an Energy Method

Influence analysis on the effect of rail fastening parameters on the vibration response of track–bridge system

Investigating noise radiation pattern of railway bridges for urban rail transit

Study on Structure-Borne Noise Characteristics of Long-Span Steel Truss Bridge in Urban Rail Transit

Low-frequency noise radiation from traffic-induced vibration of steel double-box girder bridge