Abstract:The increasing environmental consideration and the growth of instability of the energy market call for methods that can process the organic fraction of municipal solid waste (OFMSW) into fuel instead of disposal. Due to the pyrolysis and gasification that are efficient procedures to achieve valuable products, gasification of OFMSW with different particle sizes and compositions was carried out in the presence of Ni and Ni‐Ce‐loaded Y‐zeolite in a multizone tubular kiln reactor. During the experiments, 500°C was applied in the first reactor zone, while the 2nd zone was at an elevated temperature of 600°C or 900°C in the presence of steam. The combined pyrolysis and gasification experiments were also carried out without a catalyst with the same operating conditions. The feedstock was collected from the organic fraction of a Hungarian mechanical‐biological treatment (MBT) plant and was separated into four different fractions based on particle size: <1 cm dry biomass and fine particles, 1‐2 cm paper‐rich, 2‐6 cm paper and plastic‐rich feedstocks, and <6 cm mixture of these fractions. During the experimental work, product yields; gaseous product composition; the ratio of H2/CO, CO2/CO, and CH4/CO; and lower heating value were determined in the function of feedstock composition, the applied temperature, and catalysts. It was found that the hydrogen content and H2/CO ratio of gaseous products were increased due to catalyst application and temperature elevation in the 2nd reactor zone. The addition of Ce to the Ni/Y‐zeolite catalyst was advantageous in the case of hydrogen formation at a lower temperature (600°C). The hydrogen and methane content of products obtained from the catalytic pyrolysis‐gasification of paper and plastic‐rich OFMSWs on elevated temperatures were higher, which increased the lower heating value of those products. Based on the elemental analysis of the obtained solid residues, it was found that paper/plastic‐rich feedstock released hydrogen and carbon with a higher extent. 1‐2 cm feedstock‐related solid residues had the highest H/C ratio which caused a 12.5‐12.8 MJ/kg gross heating value. As a result, combined pyrolysis and gasification appear to be an efficient method to attain valuable outputs from OFMSW not only in gas but also in solid products.

Experimental study of biomass waste gasification: Impact of atmosphere and catalysts presence on quality of syngas production

Analysis on low-temperature polyethylene pyrolysis and gasification in different atmospheres

High quality syngas production from catalytic steam gasification of biomass with calcium-rich construction waste

A Comparative Analysis of Waste Biomass Pyrolysis in Py-GC-MS and Fixed-Bed Reactors

Effect of Air Equivalence Ratio on the Characteristics of Biomass Partial Gasification for Syngas and Biochar Co-Production in the Fluidized Bed

Syngas Purpose Pyrolysis‐Gasification of Organic Fractions of MSW over Metal‐Loaded Y‐Zeolite Catalysts

Syngas Characteristics From Catalytic Gasification of Polystyrene and Pinewood in CO2 Atmosphere

Pyrolysis of Biomass Wastes into Carbon Materials

STUDY ON THE INFLUENCE OF MSW PROPERTIES UPON ITS GASIFIED PRODUCTS

Syngas Composition: Gasification of Wood Pellet with Water Steam through a Reactor with Continuous Biomass Feed System

Study on Steam Co-Gasification of Waste Tire Char and Sewage Sludge

Investigation of regeneration cycles with different catalysts on steam gasification of biomass

Experimental study on CO 2 co-gasification characteristics of biomass and waste plastics: Insight into interaction and targeted regulation method

Co-gasification characteristics of Ca-rich sludge and Fe-rich sludge under CO2 atmosphere, and potential utilization of gasification residues as renewable catalyst in biomass pyrolysis

Thermo-catalytic pyrolysis of sewage sludge and techno-economic analysis: The effect of synthetic zeolites and natural sourced catalysts

Catalytic pyrolysis of liquor-industry waste: Product and mechanism analysis

Biochar and Pyrolytic Gas Properties from Pyrolysis of Simulated Municipal Solid Waste (SMSW) under Pyrolytic Gas Atmosphere

Optimization and Techno-Economic analysis of catalytic gasification of wheat straw biomass using ASPEN PLUS model

Investigation of hydrogen-rich syngas production from biomass gasification with CaO and steam based on real-time gas release behaviors

Influence of Oxygen/Steam Addition on the Quality of Producer Gas during Direct (Air) Gasification of Residual Forest Biomass

Prediction of Chemical Composition of Gas Combustion Products from Thermal Waste Conversion