Abstract:Integrated systems are facing complex and changing environments with the wide application of atmospheric LiDAR in civil, aerospace, and military fields. Traditional analysis methods employ optical software to evaluate the optical performance of integrated systems, and cannot comprehensively consider the influence of optical and mechanical coupling on the optical performance of the integrated system, resulting in the unsatisfactory accuracy of the analysis results. Optical–mechanical integration technology provides a promising solution to this problem. A small-field-of-view LiDAR system with high repetition frequency, low energy, and single-photon detection technology was taken as an example in this study, and the Zernike polynomial fitting algorithm was programmed to enable transmission between optical and mechanical data. Optical–mechanical integration technology was employed to obtain the optical parameters of the integrated system under a gravity load in the process of designing the optical–mechanical structure of the integrated system. The experimental validation results revealed that the optical–mechanical integration analysis of the divergence angle of the transmission unit resulted in an error of 2.586%. The focal length of the telescope increased by 89 μm, its field of view was 244 μrad, and the error of the detector target surface spot was 4.196%. The continuous day/night detection results showed that the system could accurately detect the temporal and spatial variations in clouds and aerosols. The inverted optical depths were experimentally compared with those obtained using a solar photometer. The average optical depth was 0.314, as detected using LiDAR, and 0.329, as detected by the sun photometer, with an average detection error of 4.559%. Therefore, optical–mechanical integration analysis can effectively improve the stability of the structure of highly integrated and complex optical systems.

Optimization Analysis of Gate Width for Detecting Atmospheric Turbulence with Differential Image Motion LiDAR

Optimization analysis of gate width for detecting atmospheric turbulence with DIM LiDAR

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Detection of Atmospheric Boundary Layer Height in the Plum Rain Season over Hangzhou Area with Three-Dimensional Scanning Polarized Lidar

Research on Atmospheric Turbulence Observation by LiDAR Based on Imaging Detection Technology

Research on Integrated LiDAR and Multi-parameter Detection of Atmospheric Transmittance, Turbulence, and Wind

Novel Detection of Atmospheric Turbulence Profile Using Mie-Scattering Lidar Based on Non-Kolmogorov Turbulence Theory

Analysis of Detectors and Transmission Curve Correction of Mobile Rayleigh Doppler Wind Lidar

Analysis and determination of lidar geometrical factor

Turbulence Detection in the Atmospheric Boundary Layer using Coherent Doppler Wind Lidar and Microwave Radiometer

Generalized theoretical model for the imaging-based atmospheric lidar technique

Investigation of Balanced Detection and Receiver for Coherent Lidar

Depth Resolution Improvement of Streak Tube Imaging Lidar Using Optimal Signal Width

Simulation and Analysis of Mie-Scattering Lidar-Measuring Atmospheric Turbulence Profile

Research on the Detection Probability Curve Characteristics of Long-Range Target Based on SPAD Array Lidar

Analysis of Errors Induced by Angle Tuning in Direct Detection Doppler Wind Lidar

Analysis for the influence of time-domain broadening on correlation detection

Optical–Mechanical Integration Analysis and Validation of LiDAR Integrated Systems with a Small Field of View and High Repetition Frequency

Enhanced Wind-Field Detection Using an Adaptive Noise-Reduction Peak-Retrieval (ANRPR) Algorithm for Coherent Doppler Lidar

Research on optimizing the optical local-oscillator power of Coherent Doppler LiDAR to enhance wind velocity measurements

Analysis on wind retrieval methods for Rayleigh Doppler lidar