Abstract:Red fluorescent molecules suffer from large, non-radiative internal conversion rates (k(IC)) governed by the energy gap law. To design efficient red thermally activated delayed fluorescence (TADF) emitters for organic light-emitting diodes (OLEDs), a large fluorescence rate (k(F)) as well as a small energy difference between the lowest singlet and triplet excited states (Delta E-ST) is necessary. Herein, we demonstrated that increasing the distance between donor (D) and acceptor (A) in intramolecular-charge-transfer molecules is a promising strategy for simultaneously achieving small Delta E-ST and large k(F). Four D-Ph-A-Ph-D-type molecules with an anthraquinone acceptor, phenyl (Ph) bridge, and various donors were designed, synthesized, and compared with corresponding D-A-D-type molecules. Yellow to red TADF was observed from all of them. The k(F) and Delta E-ST values determined from the measurements of quantum yield and lifetime of the fluorescence and TADF components are in good agreement with those predicted by corrected time-dependent density functional theory and are approximatively proportional to the square of the cosine of the theoretical twisting angles between each subunit. However, the introduction of a Ph-bridge was found to enhance k(F) without increasing Delta E-ST. Molecular simulation revealed a twisting and stretching motion of the NC bond in the D-A-type molecules, which is thought to lower Delta E-ST and k(F) but raise k(IC), that was experimentally confirmed in both solution and doped film. OLEDs containing D-Ph-A-Ph-D-type molecules with diphenylamine and bis(4-biphenyl)amine donors demonstrated maximum external quantum efficiencies of 12.5% and 9.0% with emission peaks at 624 and 637 nm, respectively.

Efficient Thermally Activated Delayed Fluorescence Materials from Symmetric Anthraquinone Derivatives for High-Performance Red OLEDs

Anthraquinone-Based Intramolecular Charge-Transfer Compounds: Computational Molecular Design, Thermally Activated Delayed Fluorescence, and Highly Efficient Red Electroluminescence

Towards highly efficient red thermally activated delayed fluorescence materials by the control of intra-molecular π-π stacking interactions.

Efficient Blue Organic Light-Emitting Diodes Employing Thermally Activated Delayed Fluorescence

Design of Efficient Thermally Activated Delayed Fluorescence Materials for Pure Blue Organic Light Emitting Diodes.

Asynchronous multiple birth. A report of five cases.

Modulating up-conversion and non-radiative deactivation to achieve efficient red thermally activated delayed fluorescence emitters

A red thermally activated delayed fluorescence emitter with mitigated efficiency roll-off via π-stacked multiple donor-acceptor structure

High-efficiency red thermally activated delayed fluorescence emitters based on benzothiophene-fused spiro-acridine donor

Asymmetric donor-acceptor-host red thermally activated delayed fluorescent emitter for high-efficiency organic light emitting diodes

Optimizing horizontal dipole orientation and dipole-dipole interaction of thermally activated delayed fluorescent emitters for highly efficiency and low roll-off red OLEDs

Rational molecular design of efficient yellow-red dendrimer TADF for solution-processed OLEDs: a combined effect of substitution position and strength of the donors

Rational Design of Highly Efficient Orange‐Red/Red Thermally Activated Delayed Fluorescence Emitters with Submicrosecond Emission Lifetimes

Rigidity and Polymerization Amplified Red Thermally Activated Delayed Fluorescence Polymers for Constructing Red and Single‐Emissive‐Layer White OLEDs

Molecular design strategy for orange-red thermally activated delayed fluorescence emitters via intramolecular energy transfer and their application in solution processable organic light-emitting diodes

Asymmetric Thermally Activated Delayed Fluorescence Emitter for Highly Efficient Red/Near-Infrared Organic Light-Emitting Diodes

Red thermally activated delayed fluorescence emitters based on phenazine-derived electron donors and solution-processed OLEDs

Realizing High-Efficiency Orange-Red Thermally Activated Delayed Fluorescence Materials through the Construction of Intramolecular Noncovalent Interactions

High‐Efficiency Deep Red Fluorescent Material with Aggregation Induced Emission and the Application in Organic Light‐Emitting Diodes

Efficient Red Thermally Activated Delayed Fluorescence Emitters Based on a Dibenzonitrile-Substituted Dipyrido[3,2-a:2′,3′-c]phenazine Acceptor