Abstract:Red fluorescent molecules suffer from large, non-radiative internal conversion rates (k(IC)) governed by the energy gap law. To design efficient red thermally activated delayed fluorescence (TADF) emitters for organic light-emitting diodes (OLEDs), a large fluorescence rate (k(F)) as well as a small energy difference between the lowest singlet and triplet excited states (Delta E-ST) is necessary. Herein, we demonstrated that increasing the distance between donor (D) and acceptor (A) in intramolecular-charge-transfer molecules is a promising strategy for simultaneously achieving small Delta E-ST and large k(F). Four D-Ph-A-Ph-D-type molecules with an anthraquinone acceptor, phenyl (Ph) bridge, and various donors were designed, synthesized, and compared with corresponding D-A-D-type molecules. Yellow to red TADF was observed from all of them. The k(F) and Delta E-ST values determined from the measurements of quantum yield and lifetime of the fluorescence and TADF components are in good agreement with those predicted by corrected time-dependent density functional theory and are approximatively proportional to the square of the cosine of the theoretical twisting angles between each subunit. However, the introduction of a Ph-bridge was found to enhance k(F) without increasing Delta E-ST. Molecular simulation revealed a twisting and stretching motion of the NC bond in the D-A-type molecules, which is thought to lower Delta E-ST and k(F) but raise k(IC), that was experimentally confirmed in both solution and doped film. OLEDs containing D-Ph-A-Ph-D-type molecules with diphenylamine and bis(4-biphenyl)amine donors demonstrated maximum external quantum efficiencies of 12.5% and 9.0% with emission peaks at 624 and 637 nm, respectively.

High-efficiency red thermally activated delayed fluorescence emitters based on benzothiophene-fused spiro-acridine donor

High-Performance Solution-Processed Red Thermally Activated Delayed Fluorescence OLEDs Employing Aggregation-Induced Emission-Active Triazatruxene-Based Emitters

Modulating up-conversion and non-radiative deactivation to achieve efficient red thermally activated delayed fluorescence emitters

Anthraquinone-Based Intramolecular Charge-Transfer Compounds: Computational Molecular Design, Thermally Activated Delayed Fluorescence, and Highly Efficient Red Electroluminescence

Towards highly efficient red thermally activated delayed fluorescence materials by the control of intra-molecular π-π stacking interactions.

Efficient Thermally Activated Delayed Fluorescence Materials from Symmetric Anthraquinone Derivatives for High-Performance Red OLEDs

Efficient, saturated red electroluminescent devices with modified pyran-containing emitters

A heterocycle fusing strategy for simple construction of efficient solution-processable pure-red thermally activated delayed fluorescence emitters

Improving the Efficiency of Red Thermally Activated Delayed Fluorescence Organic Light‐Emitting Diode by Rational Isomer Engineering

Rational design of efficient orange-red to red thermally activated delayed fluorescence emitters for OLEDs with external quantum efficiency of up to 26.0% and reduced efficiency roll-off

Red thermally activated delayed fluorescence emitters based on phenazine-derived electron donors and solution-processed OLEDs

A red thermally activated delayed fluorescence emitter with mitigated efficiency roll-off via π-stacked multiple donor-acceptor structure

Multiplying the Efficiency of Red Thermally Activated Delayed Fluorescence Emitter by Introducing Intramolecular Hydrogen Bond

Solution-Processed Pure Red TADF Organic Light-Emitting Diodes With High External Quantum Efficiency and Saturated Red Emission Color

Asymmetric donor-acceptor-host red thermally activated delayed fluorescent emitter for high-efficiency organic light emitting diodes

Realizing Efficient Red Thermally Activated Delayed Fluorescence Organic Light-Emitting Diodes Using Phenoxazine/phenothiazine-Phenanthrene Hybrids

Highly rigid polycyclic acceptors by incorporating quinoxaline and naphthalimideacridine towards red TADF emitters

Achieving 34.3% External Quantum Efficiency for Red Thermally Activated Delayed Fluorescence Organic Light‐Emitting Diode by Molecular Isomer Engineering

Realizing 22.5% External Quantum Efficiency for Solution‐Processed Thermally Activated Delayed‐Fluorescence OLEDs with Red Emission at 622 Nm Via a Synergistic Strategy of Molecular Engineering and Host Selection

Acceptor‐Donor‐Acceptor‐Configured Delayed Fluorescence Emitters for Efficient Orange‐Red and White Devices with Low Roll‐off

A Rational Design Strategy For Red Thermally Activated Delay Fluorescence Emitter Employing 2,1,3-Benzothiadiazole Skeleton With Asymmetric Structure