Abstract:Miscible CO2 flooding gains rising popularity due to high displacement efficiency and potential carbon negativity. It is well documented that pore-level heterogeneity is one of the dominant mechanisms responsible for the variation in oil recovery efficiencies of miscible CO2 flooding. However, owing to a lack of understanding of miscible CO2 displacement behaviors at pore level, quantitative analysis of the mechanisms for the influence of pore-level heterogeneity on the oil recovery efficiency of miscible CO2 flooding remains problematical. Recently, NMR has been widely used to investigate microscopic residual oil distribution and pore-level displacement behaviors of various agents. Nevertheless, current NMR-based methods for determining microscopic residual oil distribution require the use of fluorinated oil, Mn2+ solution, or heavy water for eliminating the mutual interference of oil and water NMR signals. The differences in properties of reservoir fluids and additional agents could give rise to the change in displacement characteristics and consequently affect the analysis results on pore-level displacement behaviors. In this study, a method to determine microscopic residual oil distribution in sandstone during gas floodings based on NMR T2 spectrum without additional agents except reservoir fluids is proposed. Using the method, we can avoid the possible changes in the displacement characteristics caused by additional agents. Miscible CO2 flooding experiments are conducted with ultra-low and extra-low permeability cores. The T2 spectra of cores before and after flooding are measured using a 23 MHz low-field NMR instrument. Residual oil distributions in cores are quantitatively characterized using the proposed method, and then, oil recovery efficiencies from different-sized pore throats are evaluated. It is found that for both cores about 60% of the residual oil is distributed in pore throats with 0.03 μm radius is displaceable for miscible CO2 flooding, which indicates that the thickness of the raffinate layer in the pore should be less than 0.015 μm. More than 30% of the residual oil is distributed in unswept areas, and thus, the sweep efficiency improvement is expected to effectively enhance the oil recovery of miscible CO2 flooding. The sweep efficiency is negatively affected by the pore-size heterogeneity. For the ultra-low and extra-low permeability cores, the standard deviation of pore size is 0.39 and 1.15, respectively, and correspondingly, the sweep efficiency is 84.33% and 72.84%, respectively. In the core, the oil recovery efficiencies from swept pore throats with 3 μm radius can form a preferred flow path, which will significantly reduce the oil displacement efficiency from swept pore throats with <3 μm radius. The findings of this study can help for better understanding of the microscopic CO2 miscible displacement behaviors and the mechanisms for the influence of pore-level heterogeneity on the oil recovery efficiency of miscible CO2 flooding.

Effects of Varying Oil/Water Saturations on Miscible and Immiscible CO2 Flooding in Heterogeneous Porous Media: A Lattice Boltzmann Method Simulation Study

The Three-Dimensional Heterogeneous Simulation Study of CO2 Flooding in Low-Permeability Reservoirs

Pore-scale characterization of carbon dioxide storage at immiscible and near-miscible conditions in altered-wettability reservoir rocks

Characteristics and Mechanisms of CO2 Flooding with Varying Degrees of Miscibility in Reservoirs Composed of Low-Permeability Conglomerate Formations

Inspirations from Field-Reservoir CO2 Flooding with Different Miscible Degrees under Cross-Scale Oil Reservoir Conditions

Pore-Scale Numerical Simulation of CO2–Oil Two-Phase Flow: A Multiple-Parameter Analysis Based on Phase-Field Method

Investigation on the flow behavior and mechanisms of water flooding and CO2 immiscible / miscible flooding in shale oil reservoirs

Oil production performance and reservoir damage distribution of miscible CO2 soaking-alternating-gas (CO2-SAG) flooding in low permeability heterogeneous sandstone reservoirs

Molecular insight into the interfacial microstructural and miscible behavior of CO 2 flooding in tight reservoir

Investigation on Displacement Efficiency and Enhance Oil Recovery Performance of CO 2 and CO 2 -chemical Additive Composite System Flooding Using LBM Simulation

Front Movement and Sweeping Rules of CO2 Flooding under Different Oil Displacement Patterns

Investigation of the Influence of Formation Water on the Efficiency of CO2 Miscible Flooding at the Core Scale

A Practical Compositional Method for Simulation of CO2 Flooding in Porous and Fractured Petroleum Reservoirs

Characterization of Residual Oil Distribution in Sandstone by NMR: A Microscopic View on Oil Recovery by Miscible CO2 Flooding

Study on Enhanced Oil Recovery Mechanism of CO 2 Miscible Flooding in Heterogeneous Reservoirs under Different Injection Methods

Molecular insight into oil displacement by CO2 flooding in water-cut dead-end nanopores

Pore-Scale Study on Shale Oil–CO 2 –Water Miscibility, Competitive Adsorption, and Multiphase Flow Behaviors

Effects of Pore Structures on Seepage and Dispersion Characteristics during CO 2 Miscible Displacements in Unconsolidated Cores

Experimental investigation of carbon dioxide flooding in heavy oil reservoirs for enhanced oil recovery

Mass Transfer Analysis of CO2-Water-Rock Geochemical Reactions in Reservoirs

Effects of miscible degree and pore scale on seepage characteristics of unconventional reservoirs fluids due to supercritical CO2 injection