Analysis of Entropy Generation and Exergy Efficiency of a Micro-Combustor with a Passive Exhaust Gas Recirculation Channel

Enze Lv,Wanhao Liu,Guoxing Zhang,Aiwu Fan

DOI: https://doi.org/10.1016/j.ijhydene.2024.09.008

IF: 7.2

2024-01-01

International Journal of Hydrogen Energy

Abstract:In this study, the performance of a micro-combustor with an exhaust gas recirculation (EGR) channel was analyzed based on the second law of thermodynamics. Effects of the inlet velocity (V-in), equivalence ratio (Phi), separating wall length (L-1) and nozzle diameter (d(in)) on entropy generation and exergy efficiency of the micro- combustor were investigated. In general, chemical reaction contributes most to the total exergy destruction (>60%), followed by heat conduction, mass diffusion, and viscous dissipation. Meanwhile, all parts of the entropy generation rate increase with the increase of V-in and Phi . However, the entropy generation rates caused by chemical reaction and heat conduction decrease with the increase of L-1 . The entropy generation rates due to chemical reaction and heat conduction show opposite variation trends respect to d in . An increase of V-in and phi results in higher exergy destruction and exergy loss of the micro-combustor, the largest exergy destruction and exergy loss are 3.06 W and 5.94 W under V-in = 200 m/s and Phi = 1.0, respectively. While a longer separating plate length leads to a decrease in the exergy destruction and exergy loss. Exergy destruction and exergy loss change a little with d in and their values are around 1.6 W and 3.4 W, respectively. Exergy efficiency of the micro- combustor increases with the increase of V-in and L-1, but exhibits a non-monotonic variation with Phi . A maximum exergy efficiency of 51.3% is achieved at V-in = 200 m/s under Phi = 1.0, d(in )= 0.20 mm and L-1 = 4 mm. In addition, the exergy efficiency decreases from 38.5% to 37.5% as d in increases from 0.20 mm to 0.30 mm under the same mass flow rate.