Abstract:Geological structure of the subsurface of the Moon provides valuable information on lunar evolution. Recently, Chang׳E-3 has utilized lunar penetrating radar (LPR), which is equipped on the lunar rover named as Yutu, to detect the lunar geological structure in Northern Imbrium (44.1260N, 19.5014W) for the first time. As an in situ detector, Chang׳E-3 LPR has relative higher horizontal and vertical resolution and less clutter impact compared to spaceborne radars and earth-based radars.In this work, we analyze the LPR data at 500MHz transmission frequency to obtain the shallow subsurface structure of the landing area of Chang׳E-3 in Mare Imbrium. Filter method and amplitude recovery algorithms are utilized to alleviate the adverse effects of environment and system noises and compensate the amplitude losses during signal propagation. Based on the processed radar image, we observe numerous diffraction hyperbolae, which may be caused by discrete reflectors beneath the lunar surface. Hyperbolae fitting method is utilized to reverse the average dielectric constant to certain depth (ε¯). Overall, the estimated ε¯ increases with the depth and ε¯ could be classified into three categories. Average ε¯ of each category is 2.47, 3.40 and 6.16, respectively. Because of the large gap between the values of ε¯ of neighboring categories, we speculate a three-layered structure of the shallow surface of LPR exploration region.One possible geological picture of the speculated three-layered structure is presented as follows. The top layer is weathered layer of ejecta blanket with its average thickness and bound on error is 0.95±0.02m. The second layer is the ejecta blanket of the nearby impact crater, and the corresponding average thickness is about 2.30±0.07m, which is in good agreement with the two primary models of ejecta blanket thickness as a function of distance from the crater center. The third layer is regarded as a mixture of stones and soil. The echoes below the third layer are in the same magnitude as the noises, which may indicate that the fourth layer, if it exists, is uniform (no clear reflector) and its thickness is beyond the detection limit of LPR. Hence, we infer the fourth layer is a basalt layer.

Centimeter-scale Surface Roughness of the Chang’E Landing Regions and Implications for Radar Scattering Mechanisms

Centimeter-Scale Surface Roughness of the Chang'E Landing Regions and Implications for Radar Scattering Mechanisms

Modeling Radar Scattering from the Lunar Regolith: Parametric Study on the Effect of Roughness and Ice Inclusions on CRP Measurement

Millimeter‐ to Decimeter‐Scale Surface Roughness of the Moon at the Chang'e‐4 Exploration Region

Millimeter‐ to Decimeter‐Scale Surface Slope and Roughness of the Moon at the Chang'e‐4 Exploration Region

High-Performance Numerical Simulation of Radar Wave Scattering Due to Topographic Roughness

Regolith Thickness over the Lunar Nearside: Results from Earth-based 70-Cm Arecibo Radar Observations

Modeling polarimetric radar scattering from the lunar surface: Study on the effect of physical properties of the regolith layer

Structural Analysis of Lunar Subsurface with Chang׳E-3 Lunar Penetrating Radar

Surface Roughness and Rock Population of the Lunar Regolith: Results from 70-Cm Arecibo Radar Observations

Rover-Mounted Radar Observation of Discrete Layers Within the Top 4 Meters of Regolith at the Chang'E-3 Landing Site, the Moon

Centimeter-resolution topographic modeling and fine-scale analysis of craters and rocks at the Chang'E-4 landing site

Simulation of Multiangular Radar Echoes for Speed Measurement During CE-3 Landing on the Lunar Sinus Iridum Surface

A Numerical Model of CPR of Rough Surface with Discrete Scatterers for Analysis of Mini‐RF Data

Regolith Properties in the Chang'E-5 Landing Region of the Moon: Results from Multi-Source Remote Sensing Observations

Sub-surface stratification and dielectric permittivity distribution at the Chang'e-4 landing site revealed by the lunar penetrating radar

Meter-Scale Topographic Roughness of the Moon: the Effect of Small Impact Craters

Morphological Characterization of Decimeter- to Hectometer-Scale Impact Craters at the Chang'E-3/4/5 Landing Sites

Simulation of Radar Sounder Echo from Lunar Surface and Subsurface Structure

Unveiling the Mechanics of Lunar Regolith Erosion Through Analysis of CE-4 and CE-5 Landing Images and Fluid Simulation

In Situ Photometric properties of Lunar Regolith Revealed by Lunar Mineralogical Spectrometer on board Chang'E‐5 Lander