Abstract:CONSPECTUS: The conversion of solar energy to chemicals and the storage of this energy is one of the most promising routes to realizing a "carbon zero" society, for which particulate photocatalytic water splitting to produce hydrogen has been considered to be a clean potential route. For this purpose, many d(0) and d(10) metal-based nitrogen-incorporated oxide (including nitrogen-doped oxide and oxynitride) semiconductor photocatalysts have been developed as good candidates to harvest major visible regions of solar light and to exhibit suitable energy levels to drive water splitting. Compared to the oxide-type photocatalysts, valence bands of the nitrogen-incorporated oxide can be upshifted in consideration of the lower electronegativity of nitrogen atoms concerning the oxygen atoms. However, a high-temperature nitridation process was needed to introduce nitrogen atoms into the metal oxide lattice. Because of the poor charge balance of the N3- substitution for O2- and the strong reducing effect of the active nitrogen species at high temperature, the nitriding process tends to introduce both anionic vacancy defects as well as low-valent metal ion defects. In addition, the crystal size of (oxy)nitrides synthesized through high-temperature nitridation is generally large, and there is a lack of an effective charge-separation driving force within the bulk of the (oxy)nitrides. Because of the scarcity of surface catalytic sites, the photocatalytic activity of the (oxy)nitrides is rather low. Recently, our group has been devoted to addressing the above key challenges, especially for the d(0)-metal-based (oxy)nitrides. The new preparation routes and/or methods were carried out to enhance the nitration kinetics for the synthesis of (oxy)nitrides with low-defect concentrations and further fabricate some novel metal (oxy)nitrides. The doping strategies were developed to suppress the generation of low-valent metal ion defects. A one-pot nitridation strategy was developed to construct the type II heterostructures of two metal oxynitrides to enhance their charge separation, and a strategy for the surface modification of metal oxynitrides with inert metal oxides was developed to promote the surface hydrophilicity and the cocatalyst dispersion. In addition, an intimate and strengthened interface between the cocatalyst and the metal oxynitride photocatalyst was achieved by a sequential cocatalyst decoration method, and it was demonstrated that the strengthened interface is beneficial to enhancing the surface charge separation efficiency. Benefitting from these methods and strategies, some novel visible-light-responsive materials have been exploited for promising water splitting, and remarkably improved water splitting performances have been achieved on some typical d(0)-metal-based (oxy)nitrides regardless of H-2/O-2-evolving half-reactions and Z-scheme overall water splitting (Z-OWS) reactions. In this Account, we will give a concise summary of these methods and strategies, and the prospects of nitrogen-incorporated oxide photocatalysts for potential water splitting will be examined.

Enhancing Solar-Driven Overall Water Splitting Via Both Sacrifice and Noble Metal Free Photocatalysis: Copper Cluster/boron-Doped Carbon Nitride Catalysts

Nanoparticle Superlattices As Efficient Bifunctional Electrocatalysts for Water Splitting.

Enhancement of Solar-to-hydrogen Conversion Efficiency in Water Splitting by Optimizing Morphology of Cu2O Nanostructure and Surface Modification

Interface-Enhanced SiOx/Ru Heterocatalysts for Efficient Electrochemical Water Splitting.

Non-noble Metal Single-Atom Catalysts Prepared by Wet Chemical Method and Their Applications in Electrochemical Water Splitting

Metal-Free Catalyst with Large Carbon Defects for Efficient Direct Overall Water Splitting in Air at Room Pressure

Constructing Noble-Metal-free Z-scheme Photocatalytic Overall Water Splitting Systems Using MoS2 Nanosheet Modified CdS As a H2 Evolution Photocatalyst

Metal-Free Boron Doped G-C3n5 Catalyst: Efficient Doping Regulatory Strategy for Photocatalytic Water Splitting

Rational design of stratified material with spatially separated catalytic sites as an efficient overall water-splitting photocatalyst

An electron-hole rich dual-site nickel catalyst for efficient photocatalytic overall water splitting

Interface Engineered Co, Ni, Fe, Cu Oxide Hybrids with Biphasic Structures for Water Splitting with Enhanced Activity

Boosting photocatalytic H2 generation by assembling copper complex and carbon nanotubes onto carbon nitride polymer

Transition‐metal‐based cocatalysts for photocatalytic water splitting

Efficient photocatalytic overall water splitting on metal-free 1D SWCNT/2D ultrathin C3N4 heterojunctions via novel non-resonant plasmonic effect

Noble‐Metal‐Free Janus‐like Structures by Cation Exchange for Z‐Scheme Photocatalytic Water Splitting under Broadband Light Irradiation

Bifunctional Electrocatalyst Junction Engineering: Cop Nanoparticles In-Situ Anchored on Co3(Si2o5)2(Oh)2 Nanosheets for Highly Efficient Water Splitting

Photocatalytic overall water splitting hydrogen production over ZnCdS by spatially-separated WP and Co3O4 cocatalysts

Fabrication of 0D/2D TiO2 Nanodots/g-C3N4 S-scheme heterojunction photocatalyst for efficient photocatalytic overall water splitting

Rational Design and Characterization of Direct Z-Scheme Photocatalyst for Overall Water Splitting from Excited State Dynamics Simulations

Efficient photocatalytic overall water splitting by synergistically enhancing bulk charge separation and surface reaction kinetics in Co3O4–decorated ZnO@ZnS core-shell structures

Strategies and Methods of Modulating Nitrogen-Incorporated Oxide Photocatalysts for Promoted Water Splitting