Abstract:This study assessed the impact of calcium silicate slag (CSS), an industrial by-product of aluminum extraction from fly ash, on the reaction kinetics, compressive strength, and efflorescence of one-part sodium carbonate-activated slag (SCS). Various proportions of CSS (0%, 10%, and 20%) were used to substitute for slag. The resulting performances were evaluated through chemical shrinkage, heat liberation, compressive strength, water absorption, phase composition (XRD and TG.), microstructures (BET and BSE-EDS), and simulated efflorescence test (partially and fully immersed in deionized water). The results indicate that the CSS possesses a porous structure. The addition of CSS impairs flowability but accelerates the development of chemical shrinkage and heat liberation. The incorporation of CSS promotes the transformation of gaylussite, leading to an increase in CASH and hydrotalcite formation. Consequently, a higher compressive strength and a lower water adsorption rate are achieved. 10% CSS addition improves the splitting tensile strength of SCS under conditions of partial immersion in the efflorescence test. However, a 20% CSS substitution exacerbates the formation of efflorescence products and reduces the splitting tensile strength. These observations are associated with residual alkalis in CSS, a lower Al/Si ratio of products, and an increase in capillary pores attributed to CSS particles. This paper demonstrates the feasibility of using alkaline solid waste for slag substitution and performance regulation in SCS and reveals the underlying mechanism. The prepared CSS-SCS binder exhibits much lower energy consumption and CO2 emission than traditional cement-based material, as determined by life cycle assessment.

Effects of Urea and Sodium Tripolyphosphate on the Hydration and Leaching of Cr(VI) in Solid Waste–Based Sulfoaluminate Cement

Understanding the Role of Calcium Silicate Slag in Sodium Carbonate-Activated Green Materials: Influence on Kinetics, Strength, and Efflorescence

Effects of Alkali on Water Soluble Hexavalent Chromium in Ordinary Portland Cement

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Effect of long-term dry–wet circulations on the Solidification/stabilization of Municipal solid waste incineration fly ash using a novel cementitious material

The Effect of Calcium Sulfate on the Hydration and Properties of Red Mud-Based Calcium Ferroaluminate Cement Clinker

Recycling phosphogypsum as a sole calcium oxide source in calcium sulfoaluminate cement and its environmental effects

Effect of calcium sulfoaluminate cement on the hydration process and water resistance of phosphogypsum slag cement

Effects of calcined phosphogypsum replacement on hydration and properties of calcium sulfoaluminate cement at different curing temperatures

Experimental Study on the Environmental Effects and Mechanical Characteristics of Solidified Cr(VI)-Contaminated Soil Based on Slag and Desulfurization Gypsum

Preparation and application of alkali-activated cementitious materials in solidification/stabilization of chromite ore processing residue

Preparation and Hydration Properties of Sodium Silicate-Activated Municipal Solid Waste Incineration Bottom Ash Composite Ground-Granulated Blast Furnace Slag Cementitious Materials

Modification of Calcium Aluminate Cement with Phosphate for Incorporation of Strontium Chloride

Enhanced immobilization of metal pollutants in sewage sludge ash (SSA)-cement pastes by calcium chloride and nitrate: Experimental and DFT studies

Utilization of tricalcium aluminate as modifier on phosphogypsum-based full solid-waste cementitious material

Properties evolution of calcium sulfoaluminate cement blended with ground granulated blast furnace slag suffered from sulfate attack

Effect of calcium sulfate type and dosage on the properties of high-belite sulfoaluminate cement

Phosphogypsum as a component of calcium sulfoaluminate cement: Hazardous elements immobilization, radioactivity and performances

Stabilization mechanism of hexavalent chromium ions in portland cement-based materials

Cementitious materials modified with hematite nanoparticles for enhanced cement hydration and uranium immobilization

Factors affecting the leaching of heavy metals (Ni+2, Pb+2, Cr+3) contained in sludge waste stabilization/solidification by hydraulic benders, Part I: water/cement and waste/cement ratio in S/S mortars