Abstract:Though the complementary power field effect transistors (FETs), e.g., metal-oxide-semiconductor-FETs (MOSFETs) based on wide bandgap materials, enable low switching losses and on-resistance, p-channel FETs are not feasible in any wide bandgap material other than diamond. In this paper, we propose the first work to investigate the impact of fixed positive surface charge density on achieving normally-off and controlling threshold voltage operation obtained on p-channel two-dimensional hole gas (2DHG) hydrogen-terminated (C-H) diamond FET using nitrogen doping in the diamond substrate. In general, a p-channel diamond MOSFET demonstrates the normally-on operation, but the normally-off operation is also a critical requirement of the feasible electronic power devices in terms of safety operation. The characteristics of the C-H diamond MOSFET have been analyzed with the two demonstrated charge sheet models using the two-dimensional Silvaco Atlas TCAD. It shows that the fixed-Fermi level in the bulk diamond is 1.7 eV (donor level) from the conduction band minimum. However, the upward band bending has been obtained at Al2O3/SiO2/C-H diamond interface indicating the presence of inversion layer without gate voltage. The fixed negative charge model exhibits a strong inversion layer for normally-on FET operation, while the fixed positive charge model shows a weak inversion for normally-off operation. The maximum current density of a fixed positive interface charge model of the Al2O3/C-H diamond device is - 290 mA/mm, which corresponds to that of expermental result of Al2O3/SiO2/C-H diamond - 305 mA/mm at a gate-source voltage of - 40 V. Also, the threshold voltage Vth is relatively high at Vth = - 3.5 V, i.e., the positive charge model can reproduce the normally-off operation. Moreover, we also demonstrate that the Vth and transconductance gm correspond to those of the experimental work.

Directly Coupled Hydrogenated Diamond FET Logic Circuit with High Voltage Gain

Extreme Enhancement-Mode Operation Accumulation Channel Hydrogen-Terminated Diamond FETs with $V_{th} < -6V$ and High On-Current

Monolithically Integrated Logic Circuits Based on P-Nio Gated E-mode GaN HEMTs

High-Temperature Operation of AlGaN/GaN HEMTs Direct-Coupled FET Logic (DCFL) Integrated Circuits

High performance ionic-liquid-gated air doped diamond field-effect transistors

Ultrahigh On/Off Ratio (110) Diamond Transistors with Exceptional Reproducibility of Normally Off Characteristics

High mobility hydrogen-terminated diamond FET with h-BN gate dielectric using pickup method

Preparation of High Conductivity Hydrogenated Silicon-Doped Diamond and MOSFET

Large V TH of Normally-OFF Field Effect Transistor With Yttrium Gate Material Directly Deposited on Hydrogen-Terminated Diamond

HfAlOx/Al2O3 Bilayer Dielectrics for a Field Effect Transistor on a Hydrogen-Terminated Diamond

High-Gain Transparent Inverters Based on Deuterated ZnO TFTs Fabricated by Atomic Layer Deposition

High temperature operation of logic AND gate based on diamond Schottky diodes fabricated by selective growth method

Over 50 mA current in interdigitated diamond field effect transistor

Microwave power performance analysis of hydrogen terminated diamond MOSFET

Electrical Characteristics of Diamond MOSFET with 2DHG on a Heteroepitaxial Diamond Substrate

Theoretical study of the interface engineering for H-diamond field effect transistors with h-BN gate dielectric and graphite gate

Dynamic Performance Analysis of Logic Gates Based on p -GaN/AlGaN/GaN HEMTs at High Temperature

An enhanced two-dimensional hole gas (2DHG) C-H diamond with positive surface charge model for advanced normally-off MOSFET devices

Self-aligned gate electrode for hydrogen-terminated diamond field-effect transistors with a hexagonal boron nitride gate insulator

Integration of Lpcvd-Sinx Gate Dielectric with Recessed-Gate E-Mode Gan Mis-Fets: Toward High Performance, High Stability and Long Tddb Lifetime

1 W/mm Output Power Density for H-Terminated Diamond MOSFETs with Al2O3/SiO2 Bi-Layer Passivation at 2 GHz