Abstract:Herein, a new phase change absorbent N‐aminoethylpiperazine/diethylene glycol dimethyl ether/H2O is developed to absorb carbon dioxide in flue gas. Through a series of experimental operations, the optimal absorption and desorption conditions are found, and the mechanism and renewable energy consumption are studied to determine whether it is suitable for industrial applications. Excessive carbon dioxide (CO2) emissions can lead to environmental problems, and the use of phase change absorbents for CO2 capture has received much attention due to their excellent absorption and desorption properties. Herein, a novel liquid–liquid phase change absorbent consisting of N‐aminoethylpiperazine (AEP), diethylene glycol dimethyl ether (DEGDME), and H2O is utilized. Under the optimal absorption conditions, the absorption capacity is 1.23 mol CO2·mol−1 amine. The rich‐phase viscosity of the AEP/DEGDME/H2O solution is only 6.2 mPa s−1, and the rich phase‐to‐volume ratio is 52.7%, which is suitable for industrial applications. After five cycles of absorption–desorption experiments, the cyclic capacity reaches 0.62 mol CO2·mol−1 amine. However, it should be noted that this leads to an increase in the viscosity of the solution with time. The 13C Nuclear Magnetic Resonance characterization is used to analyze the material distribution and phase separation mechanism, and it is found that during the absorption process, the carbamate and carbonate products generated by the reaction of the amino group in the AEP with CO2 are mainly located in the rich phase, while the DEGDME and H2O mainly remain in the lean phase. In the desorption process, most of the absorbed products are decomposed, and the regeneration efficiency is 66.8%. Through the regeneration energy consumption experiment, when the regeneration efficiency is 56%–67%, the total regeneration energy consumption is 2.71–2.89 GJ t−1 CO2, which is 0.91–1.09 GJ t−1 CO2 lower than that of the regeneration efficiency of 30 wt% MEA solution at 63%, which indicates that this absorbent has certain energy‐saving advantages.

Research Progress on Phase Change Absorbents for CO2 Capture in Industrial Flue Gas: Principles and Application Prospects

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Review of research progress and stability studies of amine-based biphasic absorbents for CO2 capture

Research Progress on Amine Absorbent for CO2 Capture from Flue Gas

A Novel Phase Change Absorbent for CO2 Capture with Low Viscosity and Effective Absorption–Desorption Properties

Development and property study of two-phase absorbent for carbon capture in coal-fired flue gas

Research on Modern CO2 Absorption Process

Experimental study on CO2 capture using 2‐(2‐aminoethylamino)ethanol/N,N‐diethyl‐ethanolamine/sulfolane phase‐change absorbents

Carbon Capture From Flue Gas and the Atmosphere: A Perspective

Research progress of small molecule carbon dioxide capture agent

Porous Adsorption Materials for Carbon Dioxide Capture in Industrial Flue Gas

Evaluation of the rapid phase change absorbents based on potassium glycinate for CO 2 capture

Research progress in CO2 capture technology

Recent Developments and Consideration Issues in Solid Adsorbents for CO 2 Capture from Flue Gas

Recent Advances in the Research of High-temperature CO2 Adsorbents and Absorbents

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Pilot-Scale Experimental Study of a New High-Loading Absorbent for Capturing CO2 from Flue Gas

Recent Progress on Porous Carbons for Carbon Capture

Experimental study on the performance of a highly efficient NE‐1 absorbent for CO2 capture

Research Progress on CO2 Capture and Utilization Technology

Development progress of liquid-liquid biphasic solvents for carbon dioxide chemical absorption capture from flue gas of coal-fired power plants