Abstract:Mode-division multiplexing passive optical network (MDM-PON) breaks the capacity limitations of the current single-mode fiber PON and it has shown great potential in the next-generation access network. Few-mode erbium-doped fiber amplifier (FM-EDFA) directly determines the power budget and coverage of MDM-PON due to its simultaneous multiple-mode amplification. However, when amplifying the upstream burst-mode signals, a substantial accumulation of high-energy erbium ions occurs during the signal idle time, leading to a gain transient at the instant of signal arrival. This induces optical surges at the leading edge of the signal, significantly impacting transmission quality and potentially causing damage to optical components. To address this issue, we propose a gain-equalized FM-EDFA with gain clamping to amplify downstream and upstream channels. The gain transients caused by burst-mode signals are effectively eliminated by employing continuous downstream signals to serve as saturation signals for maintaining constant inversed erbium ions in the amplifier. Experimental results demonstrate that under gain clamping conditions, the dynamic input range for upstream LP 01 , LP 11a , and LP 11b mode channels is significantly improved, expanding from −30 dBm to −15 dBm. Even with gain clamping applied to the FM-EDFA, the gains for all modes exceed 18.5 dB, and the differential modal gain (DMG) is less than 0.5 dB. Furthermore, using the gain-clamped FM-EDFA in burst mode, the bit error rate (BER) of mode channels with the same receiver sensitivity is significantly improved by one order of magnitude. Therefore, the proposed gain-equalized FM-EDFA with gain clamping effectively mitigates gain transients, contributing to the high stability of MDM-PONs.

Hybrid Mode-Bases Multiplexed Few-Mode Erbium-Doped Fiber Amplifier for Mode Gain Equalization

Optimization of Few-Mode-Fiber Based Mode Converter for Mode Division Multiplexing Transmission

Design and Numerical Optimization of A Mode Multiplexer Based on Few-Mode Fiber Couplers

Improving Modal Gain Equalization for Few-Mode EDFA Enabled by Mode Routing Optimization

Multiple-Ring-Core FM-EDF for Weakly-Coupled MDM Amplification with Low Differential Modal Gain

Chirped Fiber Bragg Grating Enabled Mode-Dependent Gain Equalization of 2-Mode EDFA

Weakly-Coupled MDM-WDM Amplification and Transmission Based on Compact FM-EDFA

Orbital Angular Momentum Mode-Multiplexed Amplification and Transmission Based on a Ring-Core Erbium-Doped Fiber

A gain-equalized FM-EDFA with gain clamping for burst-mode signals in MDM-PON

Few-Mode Gain-Flattening Filter Using LPFG in Weakly-Coupled Double-Cladding FMF

Low-modal-crosstalk Doped-Fiber Amplifiers in Few-Mode Fiber-Based Systems

All-Optical Wavelength Conversion for Mode-Division Multiplexing Signals Using Four-Wave Mixing in A Dual-Mode Fiber

Modal gain characteristics of few-mode erbium-doped fiber amplifiers with pump mode beating

Design and analysis of annulus core few mode EDFA for modal gain equalization

Experimental Investigation on Raman Amplification for Weakly-Coupled MDM Transmission

OAM mode-division multiplexing IM/DD transmission at 4.32 Tbit/s with a low-complexity adaptive-network-based fuzzy inference system nonlinear equalizer

Amplification of Multi-Order OAM Modes With High Gain and Low Differential Modal Gain

Simultaneous realization of high gain and low DMG of four-mode EDFA under bidirectional hybrid-mode pump

A 6-LP-mode ultralow-modal-crosstalk double-ring-core FMF for weakly-coupled MDM transmission

Demonstration of Weakly-coupled MDM-WDM Amplification and Transmission over 15-Km FMF Employing IM/DD

Polarization-dependent loss measurement on mode division multiplexing system for optimal transmission of high-speed dual-polarization signals