Abstract:Mode-division multiplexing passive optical network (MDM-PON) breaks the capacity limitations of the current single-mode fiber PON and it has shown great potential in the next-generation access network. Few-mode erbium-doped fiber amplifier (FM-EDFA) directly determines the power budget and coverage of MDM-PON due to its simultaneous multiple-mode amplification. However, when amplifying the upstream burst-mode signals, a substantial accumulation of high-energy erbium ions occurs during the signal idle time, leading to a gain transient at the instant of signal arrival. This induces optical surges at the leading edge of the signal, significantly impacting transmission quality and potentially causing damage to optical components. To address this issue, we propose a gain-equalized FM-EDFA with gain clamping to amplify downstream and upstream channels. The gain transients caused by burst-mode signals are effectively eliminated by employing continuous downstream signals to serve as saturation signals for maintaining constant inversed erbium ions in the amplifier. Experimental results demonstrate that under gain clamping conditions, the dynamic input range for upstream LP 01 , LP 11a , and LP 11b mode channels is significantly improved, expanding from −30 dBm to −15 dBm. Even with gain clamping applied to the FM-EDFA, the gains for all modes exceed 18.5 dB, and the differential modal gain (DMG) is less than 0.5 dB. Furthermore, using the gain-clamped FM-EDFA in burst mode, the bit error rate (BER) of mode channels with the same receiver sensitivity is significantly improved by one order of magnitude. Therefore, the proposed gain-equalized FM-EDFA with gain clamping effectively mitigates gain transients, contributing to the high stability of MDM-PONs.

Chirped Fiber Bragg Grating Enabled Mode-Dependent Gain Equalization of 2-Mode EDFA

Optimization of Few-Mode-Fiber Based Mode Converter for Mode Division Multiplexing Transmission

Improving Modal Gain Equalization for Few-Mode EDFA Enabled by Mode Routing Optimization

A gain-equalized FM-EDFA with gain clamping for burst-mode signals in MDM-PON

Few-Mode Gain-Flattening Filter Using LPFG in Weakly-Coupled Double-Cladding FMF

Pump Optimization Experiments of All-Fiber Few-Mode Erbium-Doped Fiber Amplifiers for Low Differential Mode Gain

ERBIUM DOPED FIBER AMPLIFIER USING FIBER BRAGG GRATINGS AS GAIN EQUALIZER

Multiple-Ring-Core FM-EDF for Weakly-Coupled MDM Amplification with Low Differential Modal Gain

Weakly-Coupled MDM-WDM Amplification and Transmission Based on Compact FM-EDFA

All-Optical Wavelength Conversion for Mode-Division Multiplexing Signals Using Four-Wave Mixing in A Dual-Mode Fiber

Tunable, Gain-Clamped Double-Pass Erbium-Doped Fiber Amplifier with A Dbr Lasing Cavity Including A Fiber Bragg Grating and A Fiber Reflection Mirror

Simultaneous realization of high gain and low DMG of four-mode EDFA under bidirectional hybrid-mode pump

Design and analysis of annulus core few mode EDFA for modal gain equalization

Tunable, gain clamped double pass Erbium doped fiber

An EDFA-Gain Equalizer Based On a Sagnac Loop With an Unpumped Erbium-Doped Fiber

Low-modal-crosstalk Doped-Fiber Amplifiers in Few-Mode Fiber-Based Systems

Experiments and Simulation on the Overall DMG of Long-Haul Cascade FM-EDFA Systems

Adjustability of Differential Mode Gain for All-Fiber Few-Mode Erbium-Doped Fiber Amplifiers

Simultaneously Realizing PM-IM Conversion and Efficiency Improvement of Fiber-Optic Links Using FBG

Numerical investigations of double pass, highly selective FBG based DFB-EDFA system for enhanced gain and ASE-mitigation

Improvement of gain and noise figure in double-pass L-band EDFA by incorporating a fiber Bragg grating