Abstract:Many robotic systems, like surgical robots, robotic hands, and exoskeleton robots, use cable passing through conduits to actuate remote instruments. Cable actuation simplifies the design and allows the actuator to be located at a convenient location, away from the end effector. However, nonlinear frictions between the cable and the conduit account formajor losses in tension transmission across the cable, and a model is needed to characterize their effects in order to analyze and compensate for them. Although some models have been proposed in the literature, they are lumped parameter based and restricted to the very special case of a single cable with constant conduit curvature and constant pretension across the cable only. This paper proposes a mathematically rigorous distributed parameter model for cable-conduit actuation with any curvature and initial tension profile across the cable. The model, which is described by a set of partial differential equations in the continuous time-domain, is also discretized for the effective numerical simulation of the cable motion and tension transmission across the cable. Unlike the existing lumped-parameter-based models, the resultant discretized model enables one to accurately simulate the partial-moving/partial-sticking cable motion of the cable-conduit actuation with any curvature and initial tension profile. The model is further extended to cable-conduit actuation in pull-pull configuration using a pair of cables. Various simulations results are presented to reveal the unique phenomena like backlash, cable slacking, interaction between the two cables, and other nonlinear behaviors associated with the cable conduits in pull-pull configuration. These results are verified by experiments using two dc motors coupled with a cable-conduit pair. The experimental setup has been prepared to emulate a typical cable-actuated robotic system. Experimental results are compared with the simulations and various implications are discussed.

Research on Modeling the Output Behavior of Cable Drive Surgical Instruments

Modeling of a closed loop cable-conduit transmission system

Tracking control with external force self-sensing ability based on position/force estimators and non-linear hysteresis compensation for a backdrivable cable-pulley-driven surgical robotic manipulator

A Hybrid Method Combining Data-Driven and Model-Based Algorithms for External Force-Sensing and Haptics Control of Cable-Pulley-Driven Surgical Robotic Manipulator

Realization of Force Detection and Feedback Control for Slave Manipulator of Master/Slave Surgical Robot

Wire In The Cable-Driven System Of Surgical Robot

Dual-Loop Control of Cable-Driven Snake-like Robots

Modeling of transmission characteristics across a cable- conduit system

Learning-based Cable Coupling Effect Modeling for Robotic Manipulation of Heavy Industrial Cables

Design and modeling of motion-decoupling mechanism for cable-driven joints

Data-based Shape Self-sensing of a Cable-Driven Notched Continuum Mechanism Using Multi-dimensional Intrinsic Force Information for Surgical Robot

Low-Complexity Output Feedback Control With Prescribed Performance for Bioinspired Cable-Driven Actuator

The effect of the dilated cardiomyopathy-causing Glu40Lys TPM1 mutation on actin-myosin interactions during the ATPase cycle.

Modeling of Viscoelastic Cable-Conduit Actuation for Mri Compatible Systems

A Tension Sensor Array for Cable-Driven Surgical Robots

A Ka Band Satellite Beacon Transmitter

Hybrid Tension-Position Control of Cable-Driven Serial Manipulator to Improve Accuracy and Avoid Cable Slack and Breakage

Control Method for Robotic Manipulation of Heavy Industrial Cables

Optimal Design and Experiment of Cable-Driven Puncturing Surgery Robot for Soft Needle

A Planar Cable-Driven Under-Sensing Model to Measure Forces and Displacements

Design of a Sliding-Pin Needle Driver for a Continuum Surgical Robot.