Abstract:Electromagnetic forming (EMF) is a high-speed process that uses pulsed electromagnetic force to drive metal forming. The impact velocity significantly affects the deformation behavior of the workpiece in the die and it can be used to guide the process parameters design. Due to the constraints of narrow space, it is difficult to construct a suitable optical path for noncontact measurement methods. The tactile measurement device is another low-cost and effective method, but most designs currently used in EMF have the shortcomings of inconsequence contact probe structure and low signal-to-noise ratio (SNR), which limit their application in the EMF process. To improve the performance and broaden the application scope of the low-cost tactile measurement method, a more durable contact probe structure and easily implemented external circuit topology connected to probes are introduced in this article. The influence of the characteristic parameters of the probe structure on the measurement results is investigated through finite element simulation and the structure is optimized. The equivalent circuit diagram of the measurement system is constructed and the analytical expression of the output signal is derived. The influence of the circuit parameters on the output signal is analyzed, and the stability and SNR of the measurement system are improved by optimizing the circuit parameters. Therefore, a robust and low-cost impact velocity measurement system for the EMF experiment is constructed. The accuracy and feasibility are confirmed through high-speed camera experiments and simulation analysis. The experimental results show that the maximum relative error of the collision moment and impact velocity is 3.32% and 7.34%, respectively, which shows good performance and confirms the potential for application in the EMF process.

A Non-contact Electromagnetic Motion Measurement Method

A Novel Vibration Velocity Measurement Method for Electromagnetic Vibrators

Divisionally Analytical Reconstruction of the Magnetic Field Around an Electromagnetic Velocity Probe

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

Study of Differential Magnet-moving Type Velocity Sensor

Noncontact Distance and Amplitude-Independent Vibration Measurement Based on an Extended DACM Algorithm

Contactless Current Measurement for Enclosed Multiconductor Systems Based on Sensor Array.

A Method Based on Measured Boundary Conditions for Reconstructing the Magnetic Field Distribution of an Electromagnetic Mechatronic System

Motion Induced Eddy Current Sensor for Non-Intrusive Vibration Measurement

Noncontact structural dynamic characteristics identification method and its test verification

The Application of Non-Invasive Sensor in Unbalanced Three-Phase Current Detecting

A Dual-Beam Differential Method Based on Feedback Interferometry for Noncontact Measurement of Linear and Angular Displacement

Cooperative Rotor Position Estimation of Active Magnetic Bearings with Unsaturated Magnetic Bias

Noncontact acousto-electromagnetic measurement of mechanical resonance in electronic systems

A Novel Eddy Current Sensor for Displacement Measurement with High Accuracy and Long Range

A Displacement Sensing Method Based on Permanent Magnet and Magnetic Flux Measurement

An Absolute Linear Displacement Sensor Based on Orthogonal Dual Traveling Wave Magnetic Field

Non-Contact Measurement of Electrolyte Solution with a Passive Coil Placed in Inductive Coupling System

An Impact Velocity Measurement System for Electromagnetic Forming Process

A Position Measurement Method for 3-Degree-of-freedom Motion Based on Magnetic Detection.

Measurement Technology of Eddy Current Sensor Array