Abstract:Silicon (Si) has attracted worldwide attention for its ultrahigh theoretical storage capacity (4200 mA h g−1), low mass density (2.33 g cm−3), low operating potential (0.4 V vs. Li/Li+), abundant reserves, environmentally benign nature, and low cost. It is a promising high-energy-density anode material for next-generation lithium-ion batteries (LIBs), offering a replacement for graphite anodes owing to the escalating energy demands in booming automobile and energy storage applications. Unfortunately, the commercialization of silicon anodes is stringently hindered by large volume expansion during lithiation–delithiation, the unstable and detrimental growth of electrode/electrolyte interface layers, sluggish Li-ion diffusion, poor rate performance, and inherently low ion/electron conductivity. These present major safety challenges lead to quick capacity degradation in LIBs. Herein, we present the synergistic effects of nanostructured silicon and SrTiO3 (STO) for use as anodes in Li-ion batteries. Si and STO nanoparticles were incorporated into a multiwalled carbon nanotube (CNT) matrix using a planetary ball-milling process. The mechanical stress resulting from the expansion of Si was transferred via the CNT matrix to the STO. We discovered that the introduction of STO can improve the electrochemical performance of Si/CNT nanocomposite anodes. Experimental measurements and electrochemical impedance spectroscopy provide evidence for the enhanced mobility of Li-ions facilitated by STO. Hence, incorporating STO into the Si@CNT anode yields promising results, exhibiting a high initial Coulombic efficiency of approximately 85%, a reversible specific capacity of ~800 mA h g−1 after 100 cycles at 100 mA g−1, and a high-rate capability of 1400 mA g−1 with a capacity of 800 mA h g−1. Interestingly, it exhibits a capacity of 350 mAh g−1 after 1000 lithiation and delithiation cycles at a high rate of 600 mA hg−1. This result unveils and sheds light on the design of a scalable method for manufacturing Si anodes for next-generation LIBs.

Mitigating the Capacity Fading of Silicon Nanoparticles Through Double Carbon Coatings and Cobalt Doping

Enabling Stable High Lithium Storage of Si Anode Via Synergistic Effects of Nanosized Fe 3 C and Partially Graphitized Porous Carbon

Enabling Stable High Lithium Storage of Si Anode Via Synergistic Effects of Nanosized Fe3C and Partially Graphitized Porous Carbon

Nano-Fe3C In-Situ Embedded into Porous Carbon Wrapped Nano-Si Composite Towards Stable High-Performance Lithium-Ion Battery Anode

Enhanced stability and kinetic performance of sandwich Si anode constructed by carbon nanotube and silicon carbide for lithium-ion battery

Carbon Nanofiber Cages and Interface Engineering Stabilizing Silicon-Based Anode for High-Performance Lithium-Ion Batteries

Boosting lithium storage performance of Si nanoparticles via thin carbon and nitrogen/phosphorus co-doped two-dimensional carbon sheet dual encapsulation

To Achieve Controlled Specific Capacities of Silicon-Based Anodes for High-Performance Lithium-Ion Batteries

Nitrogen-doped Carbon Coated Silicon Derived from a Facile Strategy with Enhanced Performance for Lithium Storage

Constructing three-dimensional N-doped carbon coating silicon/iron silicide nanoparticles cross-linked by carbon nanotubes as advanced anode materials for lithium-ion batteries

Si/C Composite Embedded Nano-Si in 3D Porous Carbon Matrix and Enwound by Conductive CNTs As Anode of Lithium-Ion Batteries

Carbon-Coated Si Nanosheets as Anode Materials for High-Performance Lithium-Ion Batteries

Enhancing Electrochemical Performance of Si@CNT Anode by Integrating SrTiO3 Material for High-Capacity Lithium-Ion Batteries

Carbon Nanofiber Interlayer: a Highly Effective Strategy to Stabilize Silicon Anodes for Use in Lithium-Ion Batteries

“Nano-Skeleton” Si-SiOx@C Anodes towards Highly Stable Lithium-ion Batteries

Building sandwich-like carbon coated Si@CNTs composites as high-performance anode materials for lithium-ion batteries

A Facile, One-Step Synthesis of Silicon/Silicon Carbide/Carbon Nanotube Nanocomposite as a Cycling-Stable Anode for Lithium Ion Batteries

Si Nanoparticles Embedded in Porous N-Doped Carbon Fibers as a Binder-Free and Flexible Anode for High-Performance Lithium-Ion Batteries

Stabilizing Porous Micro-Sized Silicon Anodes Via Construction of Tough Composite Interface Networks for High-Energy-density Lithium-Ion Batteries

Robust Nitrogen/Sulfur Co‐Doped Carbon Frameworks as Multifunctional Coating Layer on Si Anodes Toward Superior Lithium Storage

Lithiation of silicon nanoparticles confined in carbon nanotubes.