Abstract:The zero-sequence loop inherently exists in the structure of the three-phase open-end winding permanent-magnet synchronous machine (OW-PMSM) system with common dc bus, which provides the circulating path for zero-sequence current (ZSC) and consequently causes the torque ripple and extra system loss. Besides, the common-mode voltage (CMV), which can cause many negative effects, such as the bearing current and the failure of motor bearing, is another concern in the driving system. However, the simultaneous suppression of ZSC and the CMV control of the devices is investigated mainly in the application of the induction machine system and the multiphase OW-PMSM system, whereas it is ignored in the application of the three-phase OW-PMSM system, in which the suppression of ZSC is more complex considering the effect of flux linkage harmonic components. On this basis, this article proposes a strategy that can not only suppress the ZSC, but also eliminate the ripple of CMV in the three-phase OW-PMSM system. In the proposed method, the suppression of ZSC is achieved by synchronously adjusting the duration time of each phase within every control cycle based on the reference voltage of zero-sequence control loop, which can simplify the conventional rearrangement-based scheme. Furthermore, the duration time of each phase is distributed into each switch device of the two inverters, with the principle of eliminating the ripple of CMV. Consequently, both the suppression of ZSC and the CMV control can be achieved easily. Furthermore, the influence of dead time on the CMV control is analyzed, indicating that the CMV control is irrelevant with the dead time. Moreover, the effective modulation range of the proposed technique is analyzed. Finally, the experimental validation is conducted on a three-phase OW-PMSM system with common dc bus.

Eliminating Common Mode Voltage and Suppressing Conducted EMI Based on Discontinuous PWM for General Two-Unit PMSMs

Improved Vector Sequence Modulation Strategy for Suppressing Conducted EMI in Three-Phase PMSMs

High-Frequency Current Harmonic Analysis and Suppression in Dual Three-Phase PMSMs with Advanced Carrier Phase-Shift PWM

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Common Mode Voltage Elimination in Dual-Inverter-fed Six-Phase Open-End Winding PMSM Drives with a Single DC Supply

Four-Module Three-Phase PMSM Drive for Suppressing Vibration and Common-Mode Current

Discontinuous PWM-based common-mode voltage suppression method for three-phase inverter

PWM harmonics reduction for dual-branch three-phase PMSMs using interleaving topology

A new PWM strategy to reduce the common-mode voltage

Multisector Three-Phase PMSM Drive System with Low-Frequency and High-Frequency PWM Noise

A Sensorless Drive Strategy for Open-End Winding PMSM with Common DC Voltage Based on Lower Switching Frequency

A Novel Pulse Width Modulation Strategy Used for Permanent Magnet Synchronous Motor Drives

Zero-Sequence Current Suppression Strategy with Common-Mode Voltage Control for Open-End Winding PMSM Drives with Common DC Bus

A Carrier-Based Pwm Method with Zero-Sequence Current Elimination for Multiphase Double-End Winding Drives

An Improved Near-State Pulse-Width Modulation with Low Switching Loss for a Permanent Magnet Synchronous Machine Drive System

Pwm Frequency Noise Reduction In Dual-Segment Three-Phase Pmsm With Magnetically Coupled Inductors And Parallel Interleaved Inverters

An Optimized Modulation of Torque and Current Harmonics Suppression for Dual Three-Phase PMSM

Novel SVPWM for Open Winding PMSM Drives With Simultaneous Common Mode Voltage Control and Full Frequency Zero Sequence Current Suppression

A Combined Pwm Algorithm to Eliminate Spikes of Common Mode Voltages

Current-balance Mode-based Unified Common-Mode Voltage Elimination Scheme for Dual Three-Phase Motor Drive System

A Hybrid PWM Scheme for Stator Loss Reduction of Two Parallel Interleaved Inverter-Fed PMSM Drive with a Minimized Switching Loss