Abstract:The present study revealed experimentally flame spread behavior over high-conductivity copper (Cu) core electrical wire in sub-atmospheric pressures, and compares those with relative low-conductivity nickel-chrome (NiCr) core electrical wire, to quantify the evolutions of "wire-driven" and "flame-driven" heat transfer mechanisms in supporting flame spread with pressure decreasing. Polyethylene (PE) insulated Cu electrical wires with inner core diameter (d(c)) of 0.30 mm, 0.50 mm 0.80 mm and insulation thickness (delta(p)) of 0.15 mm, 0.20mm and NiCr core electrical wires with inner core diameter (d(c)) of 0.30 mm, 0.50mm and insulation thickness (delta(p)) of 0.15 mm were studied with ambient pressure ranged from 100 kPa to 40 kPa. Results showed that the blue flame height (or the "flame standoff distance" from the bottom edge of the high temperature yellow flame region to wire surface), and the flame base width both increased as the pressure decreased. The flame spread rate (FSR) of NiCr-core electrical wire just increased; however, that of Cu-core electrical wire first decreased then increased as the ambient pressure decreased. The critical pressure (P*) for the turning of FSR variation of Cu-core wire with pressure was larger as the core diameter was smaller or the insulation was thicker. The "wire-driven" and "flame-driven" heat transfer mechanisms in controlling the flame spread behavior over electrical wires with metal core were well verified by the experimental results shown in the present study. The relative importance of "wire-driven" heat transfer mechanism decreased, while that of "flame-driven" increased, as the ambient pressure is reduced. The findings of the present study will be essential for simulative study of flame spread behavior over electrical wires concerning the core conductivity effect and the evolutions of controlling heat transfer mechanisms.

Arc Erosion Characteristics of Cables with Heatproof Insulations in AC Series Circuits at Low Pressure

Study on arc duration and erosion characteristics of cable electrodes in AC series circuits

Analysis of overload induced arc formation and beads characteristics in a residential electrical cable

Effect of Various Radiant Heat Fluxes on the Types and Characteristics of Short Circuit on Residential Electrical Cables

Experimental Study on the Thermoplastic Dripping and Flame Spread Behaviors of Energized Electrical Wire under Reduced Atmospheric Pressure

An Experimental Study on Flame Spread over Electrical Wire with High Conductivity Copper Core and Controlling Heat Transfer Mechanism under Sub-Atmospheric Pressures

Experimental Research on the Thermal Characteristic of Low-Voltage Alternating Current (AC) Arc Faults

Experimental Study on the Generation of Arc Beads from Conductors by Arc Discharge

Optical Diagnostic Characterization of the Local Arc on Contaminated Insulation Surface at Low Pressure

Lower pressure dripping limits of inclined polyethylene-insulated wires during flame spreading under different oxygen concentrations

Metallurgical analysis of the ‘cause’ arc beads pattern characteristics under different short-circuit currents

Influence of Arc Size on the Ignition and Flame Propagation of Cable Fire

The Influence of Medium on Low-Voltage Circuit Breaker Arcs

High Temperature Erosion Properties of Arc-Sprayed Coatings Using Various Cored Wires Containing Ti–Al Intermetallics

Modeling the development of low current arcs and arc resistance simulation

Arc stability and ablation characteristics in O2, N2, and air environments

Analysis of Pressure Rise in a Closed Container Due to Internal Arcing

Failure characteristic of class 1E electrical cable used in the nuclear power plant exposed to fire

Numerical investigations of AC arcs' thermal characteristics in the short gap of copper-cored wires

AC corrosion analysis of the buffer layer in HV corrugated-aluminum sheathed power cables

An experimental study on the thermal characteristics and heating effect of arc-fault from Cu core in residential electrical wiring fires