Abstract:<div class="section abstract"><div class="htmlview paragraph">Tire forces and moments play an important role in vehicle dynamics and safety. X-by-wire chassis components including active suspension, electronic powered steering, by-wire braking, etc can take the tire forces as inputs to improve vehicle’s dynamic performance. In order to measure the accurate dynamic wheel load, most of the researches focused on the kinematic parameters such as body longitudinal and lateral acceleration, load transfer and etc. In this paper, the authors focus on the suspension system, avoiding the dependence on accurate mass and aerodynamics model of the whole vehicle. The geometry of the suspension is equated by the spatial parallel mechanism model (RSSR model), which improves the calculation speed while ensuring the accuracy. A suspension force observer is created, which contains parameters including spring damper compression length, push rod force, knuckle accelerations, etc., combing the kinematic and dynamic characteristic of the vehicle. Subsequently, the wheel load can be obtained by solving the above nonlinear system using Extended Kalman Filtering (EKF). Validation experiments are conducted on a quarter-suspension model as well as a Formula Student race car under standard working conditions. The car is equipped with sensors for the signals required by the algorithm as well as signal processing units. While calculations are performed, the conventional acceleration-based estimation method is used for comparison. The experimental results show that the measurement error of the method in this paper is significantly smaller than that of the traditional method, and it has higher sensitivity to dangerous conditions such as bumps and rollovers, which is of greater significance for the usage of wheel load for vehicle control and active safety.</div></div>

Design of CDC Semi-active Suspension State Observer Considering Additional Dynamic Forces

State Observers for Suspension Systems with Interacting Multiple Model Unscented Kalman Filter Subject to Markovian Switching

Integrated Model Predictive Control and Adaptive Unscented Kalman Filter for Semi-Active Suspension System Based on Road Classification

Analysis and Design of Suspension State Observer for Wheel Load Estimation

Observer Design Based on Nonlinear Suspension Model with Unscented Kalman Filter

A Dual-Observer Design for Nonlinear Suspension System Based on Feedback Linearization

State Observer-Based Sliding Mode Control for Semi-Active Hydro-Pneumatic Suspension

Load-Dependent Observer Design for Active Suspension Systems

State Estimation and Damping Control for Unmanned Ground Vehicles with Semi-Active Suspension System

Design of robust active load-dependent vehicular suspension controller via static output feedback

Feedback Linearization Kalman Observer Based Sliding Mode Control for Semi-Active Suspension Systems.

Design of Vehicle Vibration State Observer for Hydro-Pneumatic Suspension

A New Model-Free Adaptive Sliding Controller for Active Suspension System.

Nonlinear Tracking Control Based on Extended State Observer for Vehicle Active Suspensions with Performance Constraints

Control Strategy for Semi-Active Suspension Based on Suspension Parameter Estimation

Observer-based hybrid control algorithm for semi-active suspension systems

Adaptive suspension state estimation based on IMMAKF on variable vehicle speed, road roughness grade and sprung mass condition

Observer-based robust gain-scheduled control for semi-active air suspension systems subject to uncertainties and external disturbance

Adaptive Sensor Fault Accommodation for Vehicle Active Suspensions Via Partial Measurement Information

Adaptive Fuzzy Observer Control for Half-Car Active Suspension Systems with Prescribed Performance and Actuator Fault

Adaptive Robust Nonlinear Active Suspension Control Using an Observer-Based Modified Sliding Mode Interval Type-2 Fuzzy Neural Network