Abstract:Optical wireless communication (OWC) using the ultra-broad spectrum of the visible-to-ultraviolet (UV) wavelength region remains a vital field of research for mitigating the saturated bandwidth of radio-frequency (RF) communication. However, the lack of an efficient UV photodetection methodology hinders the development of UV-based communication. The key technological impediment is related to the low UV-photon absorption in existing silicon photodetectors, which offer low-cost and mature platforms. To address this technology gap, we report a hybrid Si-based photodetection scheme by incorporating CsPbBr perovskite nanocrystals (NCs) with a high photoluminescence quantum yield (PLQY) and a fast photoluminescence (PL) decay time as a UV-to-visible colour-converting layer for high-speed solar-blind UV communication. The facile formation of drop-cast CsPbBr perovskite NCs leads to a high PLQY of up to ~73% and strong absorption in the UV region. With the addition of the NC layer, a nearly threefold improvement in the responsivity and an increase of ~25% in the external quantum efficiency (EQE) of the solar-blind region compared to a commercial silicon-based photodetector were observed. Moreover, time-resolved photoluminescence measurements demonstrated a decay time of 4.5 ns under a 372-nm UV excitation source, thus elucidating the potential of this layer as a fast colour-converting layer. A high data rate of up to 34 Mbps in solar-blind communication was achieved using the hybrid CsPbBr-silicon photodetection scheme in conjunction with a 278-nm UVC light-emitting diode (LED). These findings demonstrate the feasibility of an integrated high-speed photoreceiver design of a composition-tuneable perovskite-based phosphor and a low-cost silicon-based photodetector for UV communication.

Ultraviolet Color Image Sensor Based on CsPbBr3 Inorganic Perovskite Nanocrystal Film.

Bioinspired UV-Visible Multispectral Imaging Sensor Enabled by Perovskite Nanocrystal Coating

Sensitive Deep Ultraviolet Photodetector and Image Sensor Composed of Inorganic Lead-Free Cs3Cu2I5 Perovskite with Wide Bandgap.

Ultrasensitive Perovskite Photodetector for Filter‐Free Color Single‐Pixel Imaging

Vapor‐phase Anion‐exchange Strategy‐assisted High-Performance CsPbCl3 Perovskite Photodetectors for Ultraviolet Imaging Applications

Ultrafast, Self-Powered, and Charge-Transport-Layer-Free Ultraviolet Photodetectors Based on Sequentially Vacuum-Evaporated Lead-Free Cs2AgBiBr6 Thin Films.

High-speed colour-converting photodetector with all-inorganic CsPbBr 3 perovskite nanocrystals for ultraviolet light communication.

Narrowband Perovskite Photodetectors based Image Array for Potential Application in Artificial Vision.

Hybrid Photodetector Based on CsPbBr3 Perovskite Nanocrystals and PC71BM Fullerene Derivative

Solution Processed and Highly Efficient UV-photodetector Based on CsPbBr3 Perovskite-Polymer Composite Film

Day-Night imaging without Infrared Cutfilter removal based on metal-gradient perovskite single crystal photodetector

Photochromic Perovskite Nanocrystals for Ultraviolet Dosimetry.

A Tetrachromatic Sensor for Imaging Beyond the Visible Spectrum in Harsh Conditions

Bioinspired, Vertically Stacked, and Perovskite Nanocrystal-Enhanced CMOS Imaging Sensors for Resolving UV Spectral Signatures.

Enhanced UV-C Detection of Perovskite Photodetector Arrays via Inorganic CsPbBr3 Quantum Dot Down-Conversion Layer

Ultraviolet-to-infrared Broadband Photodetector and Imaging Application Based on a Perovskite Single Crystal.

Ultraviolet-Visible-Near-Infrared Broadband Photodetector Enabled by Cs2AgBiBr6: Sn/Conjugated Polymer Heterojunction

Filter-free color image sensor based on CsPbBr 3−3n X 3n (X = Cl, I) single crystals

Filter-free color image sensor based on CsPbBr<sub>3−3n</sub>X<sub>3n</sub> (X = Cl, I) single crystals

Monolithic RGB-NIR Perovskite Photodetector for FusedMultispectral Sensing and Imaging

Single-pixel color imaging based on a high-performance MAPbI3 perovskite photodetector