Abstract:The health monitoring of cylindrical elements is particularly important for the safe operation of industrial production, because cylinders bear a lot of support and transmission work. Normal non-destructive evaluation techniques need special designs to suit high curvature surfaces of cylinders. Laser ultrasonic (LU) method can provide a remote and non-destructive inspection solution to solid cylinders due to its flexible adaptability to complex structures and strong penetration depth. However, constrained by the common problems of optical detection systems, the detected ultrasonic signals will suffer low signal-to-noise ratio and bad resolution from poor sample surface quality. Thus, a modified synthetic aperture focusing technique (SAFT) optimized for cylindrical components is proposed to improve the detectability of LU on small and buried defects. Mode conversion wave signals obtained by multiple separate excitations are used in SAFT imaging for the reconstruction of the defects under surface profile correction. To reduce the influence of incident waves such as direct surface acoustic wave, besides common difference method, adjacent wave subtraction algorithm based on cross-correlation is used for signal preprocessing, suppressing the incident waves and exaggerating the mode conversion waves. In numerical simulation, internal defects with diameters from 0.6 to 0.2mm with various buried depths are visualized and accurately located via the optimized SAFT algorithm using mode conversion waves. For validation, a circumferential scanning system is established in LU experiment and internal defects from 0.8 to 0.4mm in diameter inside solid cylinders are successfully detected with precise location. The results elucidate the reliability of characterizing the location of small internal buried defects in solid cylinder structures through LU-SAFT imaging.

Study on the Surface/subsurface Defects of Cylindrical Components Based on Laser Ultrasonic Technology

Surface Crack Identification on a Cylinder Using the Signal Enhancement of the Scanning Laser Line Source Method

Numerical Study for Surface-breaking Crack Detection on A Cylinder Using Laser-generated Ultrasound

Characterization of internal defects in cylindrical components using laser ultrasonic method with a modified SAFT algorithm

Detecting features of defect metal based on laser ultrasonic technique

Effect of Variable Cross-Section Rod on Laser-Induced Surface Acoustic Waves.

Quantitative Detection of Surface Defect Using Laser-Generated Rayleigh Wave with Broadband Local Wavenumber Estimation

Non-contact imaging of subsurface defects using a scanning laser source

Inspection of the Internal Defects with Different Size in Ni and Ti Additive Manufactured Components Using Laser Ultrasonic Technology

Research on Photoacoustic Synthetic Aperture Focusing Technology Imaging Method of Internal Defects in Cylindrical Components

Online Quality Monitoring in Material Extrusion Additive Manufacturing Processes Based on Laser Scanning Technology

Laser ultrasonic detection for defects of LAM components based on variable time window intensity mapping with adaptive 2σ thresholds

Using Laser Ultrasound to Detect Subsurface Defects in Metal Laser Powder Bed Fusion Components

Ultra-fast laser ultrasonic imaging method for online inspection of metal additive manufacturing

Development of laser ultrasonics inspection for online monitoring of additive manufacturing

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

Laser ultrasonic testing for near-surface defects inspection of 316L stainless steel fabricated by laser powder bed fusion

Investigation of the Effect of Artificial Internal Defects on the Tensile Behavior of Laser Powder Bed Fusion 17–4 Stainless Steel Samples: Simultaneous Tensile Testing and X-Ray Computed Tomography

Defect detection in additively manufactured AlSi10Mg and Ti6Al4V samples using laser ultrasonics and phase shift migration

Evaluation of manufacturing defects in 3D printed carbon fiber reinforced cylindrical composite structure based on laser ultrasonic testing

Advances in Online Detection Technology for Laser Additive Manufacturing: A Review