Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Design and Optimization of Dynamic Cable Configuration Device for Intelligent Cable Retractable Vehicle

Optimization design of a cable dome structure based on reliability

Dynamic Analysis of Towed Cable with Variable Length During Turning Maneuvers

Research and Analysis on Dynamic Properties of Spatial Rod-cable Deployable Structure

Design Conception and Deployment Simulation for a Highly Synchronized Extendable/Retractable Space Mast

DESIGN AND DYNAMIC ANALYSIS OF A DRIVING SYSTEM FOR ROD-CABLE DEPLOYABLE MAST

Simulation Analysis of Cable Dome Construction Process

Design and Dynamical Analysis of New Light Deployable Bridge

Cable force adjustment and post-adjusting nonlinear analysis of a cable-stayed bridge based on ANSYS

Laboratory Testing and Modeling of a High-Displacement Cable Bolt

Research on dynamic characteristics of large deformation shearer cable based on absolute node coordinate formulation method

Continuous Dynamic Analysis Method and Case Verification of Cable Structure Based on Digital Twin

Numerical Simulation Analysis of Mechanical Properties and Application of Large Deformation Cable with Constant Resistance

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

Dynamic Modeling, Workspace Analysis and Multi-Objective Structural Optimization of the Large-Span High-Speed Cable-Driven Parallel Camera Robot

Cable Installation Simulation by Using a Multibody Dynamic Model

Form finding and design optimization of cable network structures with flexible frames

Structural Design and Static Analysis of a Cable-Driven Underactuated Manipulator with Locking Devices

Mechanism Configuration and Innovation Control System Design for Power Cable Line Mobile Maintenance Robot

Design and modeling of motion-decoupling mechanism for cable-driven joints

Rapid Design for Large-Scale Parallel CFRP Cable with Multi-Source Experimental Data