Abstract:Many robotic systems, like surgical robots, robotic hands, and exoskeleton robots, use cable passing through conduits to actuate remote instruments. Cable actuation simplifies the design and allows the actuator to be located at a convenient location, away from the end effector. However, nonlinear frictions between the cable and the conduit account formajor losses in tension transmission across the cable, and a model is needed to characterize their effects in order to analyze and compensate for them. Although some models have been proposed in the literature, they are lumped parameter based and restricted to the very special case of a single cable with constant conduit curvature and constant pretension across the cable only. This paper proposes a mathematically rigorous distributed parameter model for cable-conduit actuation with any curvature and initial tension profile across the cable. The model, which is described by a set of partial differential equations in the continuous time-domain, is also discretized for the effective numerical simulation of the cable motion and tension transmission across the cable. Unlike the existing lumped-parameter-based models, the resultant discretized model enables one to accurately simulate the partial-moving/partial-sticking cable motion of the cable-conduit actuation with any curvature and initial tension profile. The model is further extended to cable-conduit actuation in pull-pull configuration using a pair of cables. Various simulations results are presented to reveal the unique phenomena like backlash, cable slacking, interaction between the two cables, and other nonlinear behaviors associated with the cable conduits in pull-pull configuration. These results are verified by experiments using two dc motors coupled with a cable-conduit pair. The experimental setup has been prepared to emulate a typical cable-actuated robotic system. Experimental results are compared with the simulations and various implications are discussed.

Cable Installation Simulation by Using a Multibody Dynamic Model

Modeling of transmission characteristics across a cable- conduit system

The Cable Modeling and Simulation Technology in Virtual Environment Based on Inverse Kinematics

Physics-based modeling and simulation for motional cable harness design

Motional Cable Harness Physical Characteristic Oriented Modeling and Kinetic Simulation Technology in Virtual Environment

Physical Modeling and Configuration Simulation for Constrained Cables of Electromechanical Products

Laboratory Testing and Modeling of a High-Displacement Cable Bolt

The Simulation of Cable Harness Based on Mass-Spring Model

Dynamic Analysis of Submarine Cable During the Process of Laying Back to the Seabed

An efficient model for dynamic analysis and simulation of cable-pulley systems with time-varying cable lengths

A Dynamic Finite Element Method for the Estimation of Cable Tension

Dynamic Modeling and Simulation of Rigid-Flexible Coupling Cable System by Absolute Nodal Coordinate Formulation

ANALYSIS ON THE INITIAL EQUILIBRIUM CONFIGURATION OF CABLE STRUCTURES

Continuous Dynamic Analysis Method and Case Verification of Cable Structure Based on Digital Twin

Frequency-Based Cable Tension Identification Using a Nonlinear Model with Complex Boundary Constraints

Physical Modeling for Motional Cable under Smooth Plane Constraint

Workspace Analysis and Cable Force Optimization of Cable-Driven Motion Simulation Platform

Static analysis of cable under self-weight and horizontal loads

Finite Element Modeling of Cable Sliding and Its Effect on Dynamic Response of Cable-Supported Truss

Exact dynamic analysis of multi-segment cable systems

Motion modeling and simulation of umbilical cable during underwater vehicle’ s deployment