Effect of Inclination Angle on the Film Cooling in a Serpentine Nozzle with Strong Adverse Pressure Gradient
Zhonghao Hui,Jingwei Shi,Li Zhou,Xiangzhi Wei,Xiaolin Sun
DOI: https://doi.org/10.1063/5.0147749
IF: 4.6
2023-01-01
Physics of Fluids
Abstract:The serpentine nozzle is widely used in military unmanned aerial vehicles to improve their viability. The film cooling technology should be used in the serpentine nozzle to cope with excessive thermal load. Strong adverse pressure gradient (APG) in the serpentine nozzle induces the recirculation zone near the upper wall downstream of the film hole, such that the effect of inclination angle on the film cooling characteristics is quite different from that in other studies. A numerical investigation was conducted to study the influence of the film hole inclination angle (a = 20 degrees, 30 degrees, 45 degrees, 60 degrees) on the film cooling characteristics in a serpentine nozzle with strong APG. Results show that the inclination angle changes the region of recirculation zone, then affects the development of counter rotating vortex pair and anti-counter rotating vortex pair (ACRVP), and finally results in different distributions of the film cooling effectiveness (FCE). For blowing ratio, M, = 0.5, 1, and 1.5, with the increase in the inclination angle, the recirculation zone expands, and the vorticity of the ACRVP increases. For M = 2, with the increase in the inclination angle, the recirculation zone first shrinks and then expands, and the vorticity of the ACRVP first decreases and then increases. Taking all the four blowing ratios into account, we find that the 30 degrees inclination angle gives the best film cooling effect, and the area-average FCE under conditions a = 20 degrees, a = 45 degrees, and a = 60 degrees is 7.5%, 5.6%, and 5.0%, respectively, lower than that under condition a = 30 degrees. Therefore, the 30 degrees inclination angle is the optimal choice for the film holes near the APG region of the serpentine nozzle.