Abstract:In recent years, failings of girders due to overturning in continuous girder bridges have repeatedly occurred in China. To investigate the overturning collapse mechanism and also to evaluate the rationality of anti-overturning design method using beam element models that are commonly adopted in practical design, detailed 3D finite solid element models of a typical single-column pier three-span continuous box girder bridge were built and a full-range numerical analysis of the models was conducted. The solid models included the prestressing effect and diaphragms. Both boundary and geometric nonlinearities were taken into consideration. Bearings were modeled considering the actual construction and dimensions of pot rubber bearings, the material characteristics and boundary conditions of rubber pads, and the contact properties between each part of the bearings. The analysis results revealed that the behavior of the bridge approached the nonlinear state at the onset of first bearing disengagement; the rotation (overturning) mechanism of the girder was gradually transitioned from deformable-body rotation to rigid-body rotation; all the end and middle bearings had been disengaged totally or locally at ultimate overturning failure. The analysis results also showed that bearing disengagements would lead to the ineffectiveness of the constraint in the transverse direction, which significantly reduced the overturning ultimate load and structural ductility before the final collapse. Prior to the first bearing disengagement, the vertical reactions calculated from the beam model were in good agreement with those from the solid model, while the transverse reactions were not. The behaviors were inaccurate after bearing disengagement in the beam models in which the movement of the rotation axis and transition of rotation mechanism failed to be realized. Reliable transverse stoppers and tensile anchors at bearing sections were recommended to efficiently improve anti-overturning stability and ductility in practical design.

Response Characteristics of Curved Girder Bridges with Single-Column Piers During the Whole Overturning Process: Experimental and Numerical Study

Experimental Study and Numerical Analysis of A Composite Bridge Structure

Static Shear Performance and Residual Axial Capacity of Rectangular RC Bridge Piers under Near-Ground Lateral Loads

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

Hysteretic behavior of GFRP retrofitted RC bridge short columns

Experimental and Numerical Study on the Behavior of Circular RC Columns under Impact Loading

Collapse Mechanism and Full-Range Analysis of Overturning Failure of Continuous Girder Bridges

Failure Analysis for Overall Overturning of Concrete Single-Column Pier Bridges Induced by Temperature and Overloaded Vehicles

Analysis of Support Abutments of Curved Bridges with Single-pedestal Piers

Analysis of Ultimate Loading Capacity of the Prestressed Concrete Curved Bridge

Bearing capacity analysis of a curvilinear box girder landscape bridge

Analysis of The Working Performance of Large Curvature Prestressed Concrete Box Girder Bridges

Dynamic performance of a concrete-filled steel tube high-pier curved continuous truss girder bridge due to moving vehicles

Experimental study on the seismic performance of a curved bridge via large-scale hybrid tests

Dynamic response performance of bridge piers under non-bottom vehicle collision

Investigation of longitudinal movements of girder ends considering various longitudinal non-linear resistances in railway suspension bridges

Deformation and internal force of multitower suspension bridges: Numerical modeling and analytical analysis

Influence of ground motion parameters on seismic response of a large-longitudinal-slope and small-radius curved girder bridge

Experimental and analytical investigation of system of horizontally curved bridge girders with tubular top flanges

Experimental study on stability of orthotropic steel box girder of self-anchored suspension cable-stayed bridge